I like the design, the continuous process, and no hinges.
@fl7422
3 жыл бұрын
this is great. genius iteration of the manual baler
@hbhmicrohomestead
Жыл бұрын
Thank you very informative. And educational.
@GWIRailroad
4 жыл бұрын
Thanks for sharing, need something like this for the cattle car. Wayne
@521farmer
2 ай бұрын
Howdie from Canada 🇨🇦 Sk thinking about how you made this going to try to make smaller bails for me rabbits got over 100 of them got to feed them pretty Good keep them happy keeps me fed cause got Gout really bad and rabbits and turkeys and chickens l can eat lots of not much red meats or wild meats sad but have to keep me strength up thks for sharing with us I signed up glad l did bring more ideas to the Table ok later it's 2024 June won't stop raining we need the hay off get second crop thks 😊
@katewizer2736
6 жыл бұрын
Thanks for explaining. I am planning on making one of those. I have recently purchased a scythe and this will be what I do with the grass clippings 😉
@bc65925
6 жыл бұрын
I think they look the best with grass instead of straw.
@suburbanryder
7 жыл бұрын
At the Sycamore IL steam show that is often the big star of the show. Kid's love the mini-bailer. :)
@praterfarm1766
7 жыл бұрын
great show very helpful
@kirbysnortfarts9819
3 жыл бұрын
Perfect for goats!!!
@navythomas8
7 жыл бұрын
Your a genius!
@bigal7713
3 жыл бұрын
Can a vertical slot be cut through the top of the box all the way to the lower horizontal slot on both sides (at the spot where you inserting the rod @4:30). That would made so easy to load the twines!
@bc65925
3 жыл бұрын
Quite probably, I'm not really sure what you are meaning however just about anything is worth trying on it.
@Tractors_Trucks_And_Pups
3 жыл бұрын
@@bc65925 think there meaning to make the slots where the twine go through be on what would be the top and bottom of the baler instead of the sides
@cliffordtaylor3556
4 жыл бұрын
How long are the metal pieces that attach to the axe handle
@bc65925
4 жыл бұрын
Just long enough to get the ram down to the correct spot. It's easiest to leave the too off and make the ram and such. Then you can figure out what the stroke will be and make the tie slots accordingly.
@joepadilla3607
4 жыл бұрын
bc65925 hi I’m Joe .... can you make one unit for me. I will buy it....please contact me... joepadilla1965@yahoo.com
Пікірлер: 22