Trimakaih kk tentang video nya...krna saya juga menggunakan alat yg sma
@sanveriveri4477
3 жыл бұрын
mantap
@ICU2HI
2 жыл бұрын
If you want to sell more of these you should answer the questions. Good luck to you.
@marcosvega1837
2 жыл бұрын
Hi. I bought this three moths ago. Works fine. Just,.. it pick only GPS and GLONASS constellations signals... What should I do to get BEIDOU, GALILEO and others constellations signals??
@siyarahmad2481
Ай бұрын
Hi sir. My Question is below 👇 In South G3 ESstar . We open EGstar and then connect with base and rover. When i click Stor point , (*The parameter Conversion Service is Offline*) is aper on screen. Point can not store. Please tell about this problem
@MrAdikoro
4 жыл бұрын
please explain for using the base using a motor battery rendy, ATR/BPN
@MrAdikoro
4 жыл бұрын
send the procedure via my email.. thanks
@gossabizu4916
3 жыл бұрын
Good , But we bought South DGPS with two rover and One base however, Rover can not collect data from the base reference at distance of 100m only so how to solve this problesm????
@geoingenieriae.i.r.l1009
5 жыл бұрын
pasame un manual del comando de voz para la instalacion de puntos estaticos
@jadepadro3393
2 жыл бұрын
How to see took picture during survey? I take picture after reading but i cant find where is the picture.
@nsikakobongeyakz4032
2 жыл бұрын
check project file
@arqge3d473
5 жыл бұрын
muy bueno el video tutorial,,,,, una consulta cual seria la manera de configurar el galaxy g1 para una observacion o levantamiento estatico?
@augus1111
4 жыл бұрын
pudiste averiguar eso?
@sarangsurveyindonesia
3 жыл бұрын
Saya pakai south galaxy g1, ada kendala di bagian layar controler yg menampillan coordinat geografis berbeda dg hasil download.... Mohon dijawab
@harshdaharwal4078
3 жыл бұрын
If base is set on known point how correction. Please give any information about this
@nsikakobongeyakz4032
2 жыл бұрын
change the coordinate of the base under settings
@rezarezar4434
3 жыл бұрын
Please tell how to display elevation when export data in dxf mode.,
@nsikakobongeyakz4032
2 жыл бұрын
in autocad? or civil 3d?
@rezarezar4434
2 жыл бұрын
Autocad
@nsikakobongeyakz4032
2 жыл бұрын
@@rezarezar4434 you will have to do a formatting ..
@nsikakobongeyakz4032
2 жыл бұрын
_point e,n,z, 90,z point height. I may not remember the correct formatting, but it looks something like this
@nsikakobongeyakz4032
2 жыл бұрын
@@rezarezar4434 You have to create a text file and write the command _point e,n,z 90 z 2.5 Z is the height e is eastings, n is northing, 90 is angle of text rotation, and 2.5 is text height You will need to verify this
Пікірлер: 26