I'm just stuck with the loops. Three days in a row now trying to figure out HOW to make the wire go smoothly round. It's crossing, going in all directions, breaking the black shouldr things in pieces while trying to escape desired path... arrrrgh, it will kill me.
@shiftymiata
8 жыл бұрын
How do you keep the poles from wobbling in the base? this is my main problem.
@BigRich-kb2wd
8 жыл бұрын
very cool :)
@anhex.5747
8 жыл бұрын
i recived level 5 but my dad would only let me build it after T4.(i'm 8 yrs old this year.).how long did U take to build level 5?
@agrholloway
7 жыл бұрын
Just constructing this but cannot see the length needed for elevator exit 2- section 4 in the instructions- pic 19. Can you please help? Thanks. Andy
@kevob
2 жыл бұрын
No level confirmed on my box, just says 10m. So frustrating, clips that look the same but are different, can't find any good video installation videos that help.This present will end up in the bin
@johnmalkovich6586
Жыл бұрын
10m is level 2
@jbrownlfctid
5 жыл бұрын
how long does the track for the loop section need to be?
@alehawk
3 жыл бұрын
I cant build the loops :/
@ChrisHQKites
3 жыл бұрын
Build them or tuning them?
@Joedon
9 жыл бұрын
what do you use to cut the tracks
@ChrisHQKites
9 жыл бұрын
+JoeDon16 A pair of small diagonal cutters, but a pair of scissors will work. After making the initial cut, round off the edge for best results.
@Joedon
9 жыл бұрын
ok thank you very much! I just received the level five and it looks pretty touch :3
@PropwashRotorsports
9 жыл бұрын
+JoeDon16 Don't worry, just read everything three times. Measure twice, cut once. It took my wife and I about 10 hours to build and tune this one. The tuning (especially the pendulum!) takes the longest, but the reward is worth it! Best of luck!
@Joedon
9 жыл бұрын
Thank you! Ok since the time you wrote this comment im stuck on the loop. The ball goes around 2 loops then flops down. :3 Any ideas?
@PropwashRotorsports
9 жыл бұрын
Your issue is currently with loop #3.Run the ball and study the transition between loop #2 and #3. that is where you need to tune. You are going to need to tighten the radius of the transition so that it is tighter, causing the ball to travel faster into the 3rd loop. That should give you enough momentum to get through the loop. Then repeat this process on the next loops. You will be ROLLIN' in no time!
Пікірлер: 16