Clean the hub mating surface rust and be sure there isn't any rust at all it's worth the little extra time. it's gonna look great ! I need to order some of those.
@OhioRiverFisherman
Жыл бұрын
Ko2's are sweet!!
@jvogler_art4708
Жыл бұрын
Put some never cease behind them I heard they’re hard to take off without it
@nevertouchzeroRT
9 ай бұрын
Absolutely tuning ❤in
@Tarz117
11 ай бұрын
Hey man do you just use stock studs? I’m wanting to do 1.25 or 1.5 for my Tacoma and not sure if I should change those out.
@vegasdavis5404
5 ай бұрын
Be smart man use longer studs
@bryandeleon6893
Ай бұрын
I think you’ll be okay if stay within that range anything bigger you would need longer studs
@jpalacess4735
3 ай бұрын
is the tired need to by flush with rhe spacer or does it have a small gap of 1/8 or less cause of the nut lug
@adamwest3637
Жыл бұрын
Do the directions say lock tight or no? Seems like a good idea
@TheSupart91
Жыл бұрын
No but but its an additional security
@EmmAyeVee
Жыл бұрын
From my experience, most wheel adapters come with threadlocker. And if they don't, just add some.
@josuegaliciaramirez4881
10 ай бұрын
Are they really that easy to install? Just take the wheel off drill the spacer in and put the wheel back on
@Trucks_n_stuff
8 ай бұрын
Well for one you have to put it to the recommended torque spec for the wheel, and two it depends on if your wheel studs are too long. Generally though, spacers are a bad idea. It's an extra point of failure and makes your hubs wear and break a lot faster because you're moving the wheel and all the weight it's holding further away from the hub which adds a lot of stress. If they aren't installed properly and come loose then youre gonna die or kill somebody. Just get rims with the correct offset for the stance you want (that also makes the hubs wear faster, but it's not as likely to fail catastrophically)
@JamesJames-pv5bd
8 ай бұрын
Your comment really helpful
@CustomWheelAdapters
Жыл бұрын
Awesome !
@Silverhands
3 ай бұрын
I’m here for the loctite
@ianreyes4972
Жыл бұрын
any problems with the wheel spacers so far?
@TWsTimberWorks
Жыл бұрын
No!
@IGNATO1966
Жыл бұрын
Cual es el torque Adecuado para ford f150 2014?
@nightwizper9345
6 ай бұрын
Yo también tengo un F150 2014, el recomendado es 140 ft-lbs, pero en el mio tengo también un level kit con 35s
@Razor911411
6 ай бұрын
10/10
@tylerangel4073
Жыл бұрын
We’re did you find the torque spec for 90 ftlb?
@TWsTimberWorks
Жыл бұрын
A Toyota forum probably, but i use 90 on lug nuts for a lot of vehicles if I’m not sure I’ll google it up and research for the specific part to be torqued
@x1u_r1e
6 ай бұрын
good or bad?
@yusefel-khatib6772
10 ай бұрын
What tires sizes? no rubbing?
@baljindersinghsidhu3959
7 ай бұрын
What's the purpose of wheel spacers?
@jrlc214
Жыл бұрын
doesn’t rub on u-turns?
@TWsTimberWorks
Жыл бұрын
No i think these tires are 11” wide
@thehighlandcruisers5194
10 ай бұрын
Whats that glue-marker for ? Can you explain
@danielh.5960
10 ай бұрын
It’s loctite, more than likely blue, even though it’s in a red tube lol
@Yungbj23
Жыл бұрын
Do we need car alignment after the spacer
@TWsTimberWorks
Жыл бұрын
NO!
@clevea9915
Жыл бұрын
How much pounds did u set it to?
@TWsTimberWorks
Жыл бұрын
I usually set wheel studs at 90lbs
@I.96AL
8 ай бұрын
What is the benefit of this ?
@cr9672
8 ай бұрын
Wheel Clearance for bigger/wider wheel
@jamiel3504
Жыл бұрын
Wheel spacers are dangerous and not worth the headaches so you’re tires can poke out lol, buy a good set of off set wheels.
@904lava
Жыл бұрын
Well those are trd 4runner wheels and they dont come in different offsets than stock
@LuisManuelHdez
Жыл бұрын
Lots if people run spacers on their vehicles. If properperky installed and torqued there are no issues. He did it right.
@jamiel3504
Жыл бұрын
@@LuisManuelHdez and lots of them go down the interstate with a wheel flying off lol, read the warning label on the box of wheel spacers before installing 🤣
@pooppoop8957
Жыл бұрын
@@jamiel3504clown don’t comment on things you don’t know
@jeffjohnson3191
Жыл бұрын
@@pooppoop8957Clown don't comment on what YOU don't know . I have been a tire tech for Belle Tire for 15 years we are legally not allowed to sell or install them for a reason.I know people who have used them no problems but also known people that have had catastrophic failures using them
Пікірлер: 42