I have the same issue with my V2 100....now I know what it is, thanks Pavel
@PavelGarmas
Жыл бұрын
Awesome that my video helped. I have used a scalpel and did cut through the solder joint between the two connectors...works now. instagram.com/p/Cj98I3ZqfY7/?igshid=YmMyMTA2M2Y=
@AdamSmith-rx6cx
Жыл бұрын
Mate, had a v2 sitting around as I couldn’t be arsed sending it back under warranty. Found the same issue, good share!
@PavelGarmas
Жыл бұрын
Good to hear! Glad video helped mate!
@JP-xv8uq
11 ай бұрын
i just reflowed my entire board when this popped up i remember throwing up a thread about this about a year or two ago and how shit their soldering was.
@JP-xv8uq
11 ай бұрын
i remembered i bitched and moaned after spending 200 and being asked to send it back + another 100 for repairs im like fuck that shit im already out 200 see if i can repair it myself.
@PavelGarmas
10 ай бұрын
Thank you for watching and for the comment mate 👍
@Archate
Жыл бұрын
Hi pavel. Im a long time subscriber and i would like to know which vesc you recommend for hummie motors. ( i have never build a eskate and find it complicated ) I recently got hummie motors i ordered back in 2019 lol. I have got a massive battery already built waiting for these motors for 3 years now. Any advised would be greatfull
@Archate
Жыл бұрын
Forgot to mention its a 12s5p
@PavelGarmas
10 ай бұрын
Well... it's a good question. Trampa are probably the best quality but are a bit more expensive. I do use the spintend v2 and Bioboards esc and have no problems. I do also have Trampa vescs with no problems but some prople got problems with all of them.
@PavelGarmas
10 ай бұрын
What are the Smps you want to run the motirs at? I got a few vescs in my garage. What voltage is the battery?
@Archate
10 ай бұрын
Smps? And voltage?! Good questions indeed..i have no ideia…how can i find out?!
@Archate
10 ай бұрын
I ended up buying a makerX? Have u ever heared about them?
@chirider73
Жыл бұрын
I just purchase this Ubox recently for a Begode K4 Extreme Bull I'm working on and at the the end of FOC motor detection /setup I got a fault of "Detection Failed. Reason: Sensor detection failed" - Is this exactly what you had ? I am beating my head in over this.
@PavelGarmas
Жыл бұрын
Switch the motors around to ensure it is not the motor. If the same side of esc still can not see the proven motor sendors then it could be the issue. My both motors do detect but one side comes up as sensorless all the time.
@chirider73
Жыл бұрын
@@PavelGarmas Thank you for the reply. Sadly I was informed that the 100v/200a VESC can only "safely" handle up to 96v 22s, my battery is at 99.5v (100.8v 24s ) and the VESC safety wouldn't allow for FOC detection... this Begode K4 has just been a thorn in my side with 2 controller fires. Again, I thank you for responding
Пікірлер: 25