Nice, simple and effective technique. Thanks for sharing.
@dazecars
8 ай бұрын
Glad you liked it, thanks for watching!
@kukuhwibisono274
10 ай бұрын
AWESOME .. Thank you a lot
@dazecars
10 ай бұрын
You are welcome!
@davidbrown3184
6 ай бұрын
Nice trick
@dazecars
6 ай бұрын
Thanks
@FelipeRicho
2 жыл бұрын
Amazing tip!!! Now i see the world different. Thank you a lot! So simple and at the same time such a bright idea.
@dazecars
2 жыл бұрын
Glad it was helpful!
@wprtube
Жыл бұрын
Great outtake.
@dazecars
Жыл бұрын
Thanks
@redzed40
2 жыл бұрын
Good idea mate
@dazecars
2 жыл бұрын
Thanks!
@av8bvma513
2 жыл бұрын
Chucks are available for your drill press, best have clutch and auto-reverse.
@dazecars
2 жыл бұрын
I am not sure what you are trying to convey. I am not power tapping. Setting it up in the drill press is only to keep the tap parallel to the hole, but the entire purpose of the video is to show how to get the same results as you would in the drill press when the part is to big to put in the drill press. With that in mind what do chucks with a clutch and auto reverse have to do with it?
@ferrellvance5565
2 жыл бұрын
wow great tip, thanks
@dazecars
2 жыл бұрын
Glad I could help
@bobuk5722
Жыл бұрын
Hi folks. No welder? No problem! Just take a piece of steel bar and use the drill press to make the 'square tap'. No drill press? Well you don't know what you are missing but just take exceptional care with making the tap guide.
@dazecars
Жыл бұрын
Good point
@wilsonvinas5906
Ай бұрын
Could i just hold it instead of clamping it? There is no room for a clamp on my project.
Пікірлер: 22