In this video, I finally installed the Smart Brake Module on my Can AM RT Limited.
I had to jump through some hoops, but in the end I got the job done.
I had to purchase the Service Manual so that I could the wiring diagram.
#CANAM
#PedalCommander
#RTLimited
#SmartBrakeModule
#ST2
I purchased the product here:
st2-systems.com
Steps I took:
1. Remove the trunk.
2. Remove the rear passenger seat.
3. Found the CIC wiring harness.
4. Located the White Wire (Brake control), the Black Wire (Ground), Orange Wire (Power)
5. I attached the Provided connectors to the respective wires.
6. located and Velcro the module to a flat place under the seat.
7. I went with the writing facing down for the blinking effect.
8. made sure everything was secured in place.
9. put the Can AM RT Limited back together.
10. Tested successfully.
Donations:
cashapp: $SebFort
Негізгі бет ST2 Smart Brake Module Installation on Can AM RT Limited
No video
Пікірлер: 13