Ko dail nya taro di plat kalau pelat nya melengkung , taro di tiang atuh bosku
@Satyabansahoo
5 жыл бұрын
What the design load of this pile. & Jack capacity
@kanarajan
5 жыл бұрын
the factored load was around 6500 kN for this test, jack around 10000kN
@user-ds4kd4eh9q
5 жыл бұрын
Which gives best result static pile load test or dynamic pile load test
@kanarajan
5 жыл бұрын
static load test is the best for measure the actual settlement. But the dynamic one is easy, low cost and quick one. skin friction and end bearing values can be evaluated separately through the PDA. Also PDA used for comment abut integrity of pile. static load test is only for settlement measurement while loading. So, it is based on your requirement dear friend.
@user-ds4kd4eh9q
5 жыл бұрын
@@kanarajan thanks
@wuhansinorocktechnologyco.718
4 жыл бұрын
Is it only necessary to purchase software and sensors?
@kanarajan
4 жыл бұрын
I don’t understand; what do you mean ? ; no special software is needed ,
@hunartaha830
Жыл бұрын
the main girder is very small
@kanarajan
Жыл бұрын
I think, u couldn’t judge the dimensions of the girder by looking this video, but it’s successfully done and sufficient
@kanarajan
Жыл бұрын
I think, u couldn’t judge the dimensions of the girder by looking this video, but it’s successfully done and sufficient
@kanarajan
Жыл бұрын
I think, u couldn’t judge the dimensions of the girder by looking this video, but it’s successfully done and sufficient
@kanarajan
Жыл бұрын
I think, u couldn’t judge the dimensions of the girder by looking this video, but it’s successfully done and sufficient
@hunartaha830
Жыл бұрын
placing dial gauges on this plate is mistake
@kanarajan
Жыл бұрын
Yes it is not recommended at all the occasions; the test load should be checked
Пікірлер: 23