Easy to understand. In you example, there is no change in basic dimension and tolerance for the WCM and RSS. Can you high light the benefits of RSS method over WCM by comparing the two results. So that we can correlate to our real life problems easily. Thank you.
@eamonnquinn9585
4 ай бұрын
good and clear tutorial on this topic - Thank you
@instituteofqualityandrelia7902
4 ай бұрын
Glad to hear that it was helpful! Appreciate your feedback!
@nandakumarwalve3146
Жыл бұрын
Very good video for basic understanging. Sir, can you suggest good book for reference for learning Stack up analysis?
@karti9229
Жыл бұрын
Hello Sir At 8:54 you have taken square root of SD (A Tolerance) + SD (B Tolerance) At 9:07 you are again calculating Square root of Previous Answer + Square root of (C Tolerance)
@instituteofqualityandrelia7902
Жыл бұрын
Hello Karti, thank you for your interest. For every dimension, you need to add variance. If all tolerances are assumed to have equal Cp, then you can add squared tolerances and take square root.
@oguzhanaydn5906
11 ай бұрын
Thank you for the video
@instituteofqualityandrelia7902
2 ай бұрын
Welcome!🙏
@karti9229
Жыл бұрын
Sir you have taken square root two times Square root od A AND b Tolerance again calculating square root of c + previous answer i have calculated square root of sd of a tolerance + sd of b tolerance + sd of c tolerance Please check Nominal Tolerance SD=Tol/6 A 25 0.5 0.083333333 B 10 0.2 0.033333333 A+B 35 C 35.25 0.2 0.033333333 GAP=C-(A+B) 0.25 0.9 0.095742711
@instituteofqualityandrelia7902
Жыл бұрын
Thank you. Apologize for the late reply. All the variances ( and tolerances) are perpendicular to each other. So we need to take square root again.
@prof.palakshareddyk4743
Жыл бұрын
Sir, please remove the flickering of the letters.
@instituteofqualityandrelia7902
Жыл бұрын
Hello professor, appreciate your feedback. I will take a note of it and avoid it in future videos. KZitem doesn't allow changes in current videos.
Пікірлер: 12