A very quick and easy video on how to check the accuracy of the the display on your STC1000 / STC-1000 temperature controller. The same method can be used on any controller with a probe (inkbird etc). You can also use this method on other temperature controllers like the inkbird.
Method -
1. Fill glass with crushed/broken ice and then top up with cold tap water to the top level of the ice.
2. Place probe into the centre of the ice/water. Try not to touch the bottom or sides of the glass.
3. Wait for the controller display to stabilize
4. If it doesn't read 0.0C or 32F, then go into "F4" function of the controller and adjust up or down by the amount you are out and press the set button. The display should now read 0C or 32F.
Any questions please ask.
Негізгі бет STC-1000 Temperature Controller Calibration - How to Check Accuracy and Calibrate
No video
Пікірлер: 48