Very nice work sir. I still need to make a steady rest. Well some day
@fab_metal_machinist
4 ай бұрын
Thank you! I looked into buying one but the ones for my lathe are Cheap and not very well made and when I looked up the dimensions, I found that it doesn't even line up with the centre line of my lathe. so the only way I could have one is, if i built it myself!
@benmoroz3278
3 ай бұрын
Well done.
@bustednuckles2
4 ай бұрын
Very nice work!
@Calligraphybooster
2 ай бұрын
Very nice work indeed! I saw CEE using a steady rest and make a smooth section on the outside of an otherwise rough pipe like yours and then move the steady over to it to have the bearings run on a better surface. Seems like a good practice, so I pass it on. Best of success with future projects!
@fab_metal_machinist
2 ай бұрын
@@Calligraphybooster sure, the pipe was just for a test.
@Calligraphybooster
2 ай бұрын
@@fab_metal_machinist I know, and your steady worked 👍.
@ÁREAJ27
4 ай бұрын
Olá amigo muito bom trabalho,gostei da luneta parabéns!!! Lhe desejo cada vez mais sucesso!!!
Пікірлер: 9