I'm 100% learning how to do new stuff..This isn't the same ol stuff that I used to wrench on in the 80s.
@michaelvargas1663
3 жыл бұрын
Thank you all for the information earlier
@aante76
3 жыл бұрын
Big thanks for them tips 🙏 have an question, do you thing I could "mirror" this mounting of the tank and get up against the crossmember for the shockmounts instead of the rear crossmember? I am planing for a bagged setup and was thinking of mounting the airtank behind the gas tank..was gonna, make the airtank "show off" from rear and at the same time making it act little like an "impact cover" if one would get rear-ended.
@jameswilliams5015
6 жыл бұрын
So I have more a question instead of a comment. So if you already know the correct measurements and bends for the ban why not just send them out already to go. It would make it ten times easier and make your clients more happy.
@jrbyers96
4 жыл бұрын
exactly!
@monkeywrenchization
5 жыл бұрын
Do you have a tank kit that is set up for fuel injection? I had the idea of putting a 5.3 engine in one of your truck kits. Hopefully using the stock pump from the doner truck that the engine came from. That way if you needed to replace the pump, it could be sourced from NAPA, ect.
Пікірлер: 6