Thank you so much for this information! I know it must have been more work and effort into it because you had to recorded it, also the struggle that was not in the videos. Truly appreciate this.!!!
@ebbayer
3 ай бұрын
Thank you so much for this video, great job. It took me three days to get it out and it is back in again and I will finish it tomorrow hopefully. BTW, the special plastic parts holding the wire-harness to the engine block I bought on AMAZON. I think I paid $12 for 20 pieces. To get the two difficult to get to bolts holding the engine and transmission together, I took a couple of moving blankets and laid them over the engine. Laying on my belly on top of the engine I got to the two bolts as I kind of new where they were. Your video also showed me that I could actually do it as I saw you doing it.
@user-sp5bn6ye8y
2 жыл бұрын
Legend. Thank for this. This actually helped more than you realise
@cameron3983
Жыл бұрын
Wholesome father son moment. Also you're the man for this vid
@mesmaayan
Жыл бұрын
Aaight, doing this TODAY! I know it gonna be a breeze thanks to your great video! I’ll be doing a rebuild and will let you know the outcome before long! ¡Gracias, compadre!
@jasonjungert1182
Жыл бұрын
Doing my 2007 hhr. Thanks for the helpful tips. Just getting started on the motor mounts! 😢
@ScareDe2
Жыл бұрын
Incredible. It is a dream and at the same time a nightmare to think about one day doing this.
@georgefekete3753
Жыл бұрын
Great work guy thanks for your fantastic attention to detail 👍
@DonaldDeberryjr
3 ай бұрын
There is also a bracket that bolts to the trans and engine! Bolts near the passenger cv axle and the engine
@followyourbliss101
7 ай бұрын
very informative - now i am not looking forward much at all to attempting this myself in order to change the timing chain/water pump... i was thinking that job is a piece of cake if the engine is out. but the removing of the engine part trade off is questionable.
@just__dave
5 ай бұрын
Been looking for this! I have an 07 with nearly 300k on it and she still runs great, but would love to pull the engine and do a complete rebuild on it. Doesn’t look nearly as difficult as I had feared.
@charlesmckenzie7101
7 ай бұрын
I think in my opinion, its easier to drop the engine cradle trans and front end put the bottom while on a lift
@user-sp5bn6ye8y
2 жыл бұрын
Take off the heatshield on the exhaust manifold and make sure the manifold isnt cracked in the middle (like mine is). Im about to pull my engine out today/tomorrow once I get the last few bolts off between the engine and transmission
@just__dave
5 ай бұрын
Agreed. Mine was cracked. Went to the junkyard to the roll the dice and 5 out of 5 that I found were also cracked.
@larryhillman6307
Жыл бұрын
When I put the top bolt in the starter I took bolt to part store got a rubber o ring that fit tight over the bolt put top bolt threw starter hole put oring over threads it held the bolt in place put starter back put bottom bolt in just a little then the top bolt and then tighten
@nardydavis24
Жыл бұрын
I just got a 08 hhr for a few hundred bucks the car runs hot even without a thermostat im planning on replacing the motor the motor that's in it came out a 08 malibu 😅
@Elturo16
Жыл бұрын
Hey! Been watching this to get ready to remove my engine. At what point did you chain up the engine to the cherry picker?
@conar2swag441
Жыл бұрын
did you ever figure out when to chain it up?
@carloserazo1286
3 ай бұрын
Thanks!
@rodneysenter3711
Жыл бұрын
How long did it take you to pull
@Mil-usos
Жыл бұрын
It took me a while because of recording procedures. Everything takes way longer when recording. I'd ball park it around 3 hours though if you have the steps down.
@rodneysenter3711
Жыл бұрын
@@Mil-usos thanks for the reply.
@josepablo6309
10 ай бұрын
I have a question,,my hhr car make noise like power steering noise but all is ok on steering is just noise ,u think can be a weel pulley bearing getting bad, any help appreciated
@just__dave
5 ай бұрын
Did you check your power steering fluid reservoir?
@donewithyoutube275
7 ай бұрын
Why make a video showing how to do something if you were learning how to do it as you did it in the video
@just__dave
5 ай бұрын
Why not? We learn from the mistakes just as much as we learn from the successes. I for one like seeing when errors aren’t edited out.
@ebbayer
3 ай бұрын
That is actually the point of a good informative video; showing the struggle and the solutions! Great video!
@noravelasquez3853
6 ай бұрын
VVT censor dónde se ubica
@muhammadfiaz8930
Жыл бұрын
I need engine 2008 Chevrolet hhr
@dottiehammock9917
11 ай бұрын
I would have liked to see him remove the engine because there is not a lot of room on the passenger side to slide the engine forward
Пікірлер: 31