I want to tell you how much you blessed me by posting this video!!!! I have the exact same water heater and it kept producing "muddy" water and then it just finally stopped heating. I did not have the funds to pay someone to install a new one, so when I found your video, you made it so easy for me to have the confidence to do it on my own. Took me 3 days and had to call a friend for "man strength" when I couldn't get the cold water connection loose, and while he was there he helped with the reinstall. (Yes America, MEN are a VALUABLE asset and women cannot do EVERYTHING) Mine was not under a cabinet but in the "basement" of the RV and not one you could sit up in, but rather had to crawl into and lay down to disconnect everything. It was an adventure but now I have hot water, no leaks and I am forever grateful that you took the time to post this.
@dominiquehopkins5009
3 жыл бұрын
You are a life saver my friend. I have to replace my water heater and did not want to pay to get it done. So I will be using this video to transfer mine out
@h.e.78739
3 ай бұрын
Hello, it would have saved you time if you hadn't filmed it! Lol But I am so glad you did! Awesome job! I'm replacing mine tomorrow, and this video takes some of the anxiety out of me. Thank you very much for this video! Great video!
@jaybeliever1479
3 жыл бұрын
You did an amazing job one-handed! Thanks for the informative and helpful video.
@teddy_awdB19
3 жыл бұрын
Agreed.
@MichaelPop72
3 жыл бұрын
Thank you for posting this my friend, your elaborating patient step by step skills and details to the job at hand are what were the determining factor of me subscribing to your channel.
@timstopics
3 жыл бұрын
Just a comment that you don't put sealant on the threads of a flare fitting. The sealing part of that connection is not the threads. Other than that great video ! Thanks !
@lylesliving
3 жыл бұрын
Thanks for the tip!
@watchmebarf
Жыл бұрын
No you don't. Just remember to get the copper line lined up centered on the fitting before screwing the nut on. And the use a soap solution on the fitting after turning the propane back on to check for leaks!
@DXEsrat
2 жыл бұрын
Appreciate your video...very good instructions. My suburban gas w/h started leaking pretty bad so I watched your video and said 'I can do this!'. Ordered the tank from HD online. Before anything I did a unit comparison just as you did (wires) than the whole removal and install took apx 50min. Only issue after was the polybutylene pipe fittings for the water inlets were leaking and copper/brass was corroded so I had to cut them off and replace with swivel elbows found at camping world for $9/each (better than shark bite fittings bc they thread onto the pipe after insertion). The funniest thing was being told by a person in the store that I should have a professional do the work on the pipes but it took me less than 5mins.
@TheHippieatheart63
Жыл бұрын
With KZitem you can get instruction right from the professionals mouth if you find the right one. Save some money that way for damn sure. Just need the proper tools. Take pictures from all angles before you take it apart, put the new one together in the same way.
@oliveriorangel4450
Жыл бұрын
Very detailed instructions, thanks for sharing your videos, step by step, is the best I’ve ever seen, it is a hard work, but also save lots of money. Thanks again.
@lamomify
Жыл бұрын
Im installing a new water heater this weekend and this video is going to be used to gelp w/the install. Great job!! Thank you!!🙏🏻💕
@emileefrank7962
2 жыл бұрын
Thankyou for making this video! I feel like your totally a dad the way you explained things! Love it
@kalebklosky7673
2 жыл бұрын
Really appreciate the post. Helped out and made the swap very fast. In and out less than an hour.
@ericaudit1233
2 жыл бұрын
I just paid almost $600 in labor to have this done. Great Job !!
@johnmunk5391
4 жыл бұрын
Nice job, one special note that most probably already know, check that gas line for leaks once you reattach the line.
@jimanderson5970
4 жыл бұрын
Bingo man you helped alot, I’m new to living in my RV, best fort I ever had. Thanks again.
@jamesmartinez1980
3 жыл бұрын
great video. had me laughing when you said "sounds like I'm making it up as I go, I probably am"...🤣
@neurosis333
3 жыл бұрын
EXCELLENT video.....tackling this project tomorrow, brother...THANK YOU!
@akwolf1434
2 жыл бұрын
Nice video. Mine doesn’t have the electric, but otherwise the same. Just an FYI that “drain plug” on the front is actually the anode rod, and depending on how often you are using your water heater, that should be checked yearly and replaced as needed. If you had never checked it, then that is probably why your it was rusted shut and why it might have started leaking.
@lylesliving
2 жыл бұрын
Thank you, yes we realized that afterward
@quoleo
3 жыл бұрын
all I needed was to know which way to turn the nut on the water heater, Thank you... New SUB
@brownsrvlifecampground9322
3 жыл бұрын
You made a very helpful video we have to place our RV hot water heater we just purchased one online waiting on it to be shipped out to us.
@budshepherd9893
2 жыл бұрын
great job but I think you might have to show your checking for propane bubbles to see if there is a leak...other than that thanks for making this video.. going to put mine in this weekend...will keep you posted..
@californiahikingadventures2249
2 ай бұрын
It looks like the genesis of your problem was not changing out the anode rod in regular maintenance . That rod sacrifices itself so the steel tank doesn’t disintegrate. The anode rod is located at that nut on the outside where it leaked and rusted the outside
@teddy_awdB19
3 жыл бұрын
Thanks for posting up this video! Really informative!
@jimburnette3319
2 жыл бұрын
Dropping screws is my middle name buddy..lol
@al1here
4 жыл бұрын
Great video you did a great job to be doing the replacement of the water heater and being the camera man. Thanks
@rafaelquezada6203
2 жыл бұрын
Great video chief!! Now I can change my water heater!! 👍🏻
@matthewknight5641
Жыл бұрын
You did good man... im fighting a 93 model atwood in a holiday rambler. Pain in the butt so far but yeah same deal. Problems while on gas and now gas side isnt working at all.
@LadyDJRaj
4 жыл бұрын
You did an excellent job! Great verbal instructions. Thanks for sharing.
@graemerichter8280
11 ай бұрын
Good to see how to remove the unit, mine is very similar. Replacing it with a Camec 13 kw instant gas heater that goes back into the same place.
@whatsit2ya247
2 жыл бұрын
Fyi, you can do all the wiring from outside, just pull 1/4 - 1/2 out and splice. No need to remove cabinet, sorry for your struggles, it is what it is, you got it done 👍
@emmanuelleallen
Жыл бұрын
He had to remove the cabinet due to water damage, from a leak caused by the water heater.
@outdoorlivingart
6 ай бұрын
Meke more videos please , I your new follower
@guy1284
4 ай бұрын
Thanks for the video!!!!
@barryseifert6053
2 жыл бұрын
I have the same water heater in my 2001 motor home it just started to do the exact same thing all i had to do is run a 3/4 npt tap threw the drain hole were it was leaking and clean up the threads. Like new again . No more leak.
@rotwilk1
2 жыл бұрын
Great vid man! Gonna give it a shot myself. Thank you so much.
@theroadking547
2 жыл бұрын
Thanks for the video. I'm about to change mine.
@timdaniels3238
3 жыл бұрын
Awesome video brother!! You crack me up! Banana sandwich lol! That video was very well done and informative thank you so much!
@lylesliving
3 жыл бұрын
Glad you got a chuckle
@ziggythetechguy5024
4 жыл бұрын
Where that water was leaking is your arode rod that spouse to be replaced once a year to keep your tank from rusting out from the inside
@ziggythetechguy5024
4 жыл бұрын
I’m talking about the outside plug by the way there should be a rod connected to the other side that keeps your tank from rusting
@lylesliving
3 жыл бұрын
Thanks for the tip!
@cheech111477
4 жыл бұрын
Great work man!!!
@mitcheldoucette8268
3 ай бұрын
Watching you try to turn those nuts was the most painful thing I’ve ever watched. Have you ever heard of a wrench?
@JrayAloha
4 ай бұрын
Just thinking its easier to clear out water in old tank by releasing the water valve in front. Then unscrew the hot & cold lines in back
@Paeoniarosa
2 жыл бұрын
Very helpful, Thank you.
@jessemaldonado7971
3 жыл бұрын
Very good 👍
@tannerpratt2437
2 жыл бұрын
When you said “lil wire nut sandwich” I had to subscribe
@hesperiafred
5 ай бұрын
What size are the water fittings. 21MM. 7/8 too large and 3/4 too small. 13/16 too small
@beckyboyd1920
2 жыл бұрын
Good video, good job.
@iair-conditiontheoutsideai3076
3 жыл бұрын
I wanted to mention if you do not replace your anode rod you will be here again in a few years that is the reason this water heater has all that rust your anode rod is completely rusted into place probably completely disintegrated within the tank and the tank has started to corrode on the inside
@lylesliving
3 жыл бұрын
Thanks, yeah that’s what we learned in this process
@peggyrussell1728
3 жыл бұрын
We have a 07 wildwood travel trailer and the gas water heater the pilot light is working but we don't have any hot water help! We replaced the ignition switch
@salba32
2 жыл бұрын
Good job! I need to replace mine but I'm wondering if all water heaters are the same. I have a 2007 Forest River Wildwood 34ft Travel Trailer. Can you tell me how much they run $ and perhaps where you purchased it?
@lylesliving
2 жыл бұрын
I believe it was about $600 but I don’t remember where we bought it. Maybe camping world?
@kellylunceford5625
3 жыл бұрын
Doing the exact same water heater next weekend. Did it fire up and run good??
@lylesliving
2 жыл бұрын
Sure did!
@trumptubemedianetwork1863
2 жыл бұрын
Awesome job. 😀
@kaylagarcia8118
2 жыл бұрын
Great video thank you :)
@garypursell7492
Жыл бұрын
Should use a backup wrench when tightening or loosening propane flare fitting
@alexusmiller3428
3 жыл бұрын
so helpful!
@JesusTorres-dr7nt
2 жыл бұрын
Where do your blue red and green wires come from my rv does nnot have them how can i install them or where do they come from any help is appreciated
@tonyagann2754
3 жыл бұрын
What do you do what do you think that your hot water heater from your how do you get rid of it
@jojester21
3 жыл бұрын
Banana sandwich on it? Lol
@redthunderfox
2 жыл бұрын
Is there anyway we can just remove it and cancel the water heater?
@dmccarty1006
3 жыл бұрын
Would you happen to know the depth needed for this heater? I got about 20 1/2 inches
@lylesliving
3 жыл бұрын
I’m sorry, I don’t :-/ we actually don’t live in the camper anymore
@erdoganulu3713
2 жыл бұрын
👍👍👍
@briizcustoms9543
Жыл бұрын
What is that wiring for?
@jacklong1440
3 жыл бұрын
Are you still active? I have a wiring question?
@lylesliving
3 жыл бұрын
I’m still active on KZitem but we actually don’t live in a camper anymore so not sure how much help I could give you
@tonyagann2754
3 жыл бұрын
What do I do with the old one
@karlireed7364
2 жыл бұрын
What size wire nuts
@Username72589
3 жыл бұрын
Can you say please what the water heater is called? Where did you get? How much?
@lylesliving
3 жыл бұрын
It was about $500 from camping world
@iair-conditiontheoutsideai3076
3 жыл бұрын
@@thenightowl5403 it is a suburban water heater they make ones that are gas and electric or just gas also wanted to mention do not purchase from camping world like he has they are notorious for very bad service purchase from eBay or an suburbans website
@joedoakes8307
2 жыл бұрын
WHY didn't you just UNscrew the wire nuts instead of cutting the wires on the old heater ?
@mickeybozeman8642
Жыл бұрын
Some one needs to learn how to use a pair of pliers
@claudehendry3644
3 жыл бұрын
no need for teflon tape on gas fittings
@spechnoch
3 жыл бұрын
AMATURE
@lylesliving
3 жыл бұрын
I believe you mean amateur 😬
@adkchip1
3 жыл бұрын
@@lylesliving he still gave me useful information. Vid was very helpful!
Пікірлер: 86