This really helped me figure out my problem. It ended up being the magnet had moved. Thanks for posting this.
@MaxamillionEd
5 ай бұрын
Saved me frustration. Thanks
@darrenroos6408
2 жыл бұрын
Hi Danny, if you are ever in the Orange County, CA area and want a free set of Gen 2 Rockslide Engineering Step Slider skid plates for a JL Wrangler, I have some that are taking up space in my storage unit in Anaheim.
@kdard89
2 жыл бұрын
I love the steps when they work, but I'm tired of the motors sounding so weak and the step only going half way up. I'm using a Dupont Teflon Dry lube and it seems like it never lasts long.
@jabrealthecoder2825
Жыл бұрын
Same here! I like them too, but they have progressively gotten worse always halfway up!
@chrism1701
2 жыл бұрын
Is this a normal problem with these sliders....their on my to buy list and this is actually the first time reading of such issues
@darrenroos6408
2 жыл бұрын
The Generation 3 step has improved in design. I think the weak link in the Gen 2 performance was the strut used to assist the lifting and lowering of the step. The strut has now been replaced with a spring design in the Gen 3.
@photoapeal
Жыл бұрын
@@darrenroos6408 I have the Gen 3 steps and I'm here because one side was stuck down. I was able to get it to retract after I shut the door and after a few times of resetting it finally worked. it was just clicking even with the swtich off but I think it's working properly for now.
@davidbautista9679
Жыл бұрын
i have these sliders been having issue with battery keeps dying. even when i turn the switch off. any ideas?
@jeremymachado2773
Жыл бұрын
I have the same problem
@davidbautista9679
Жыл бұрын
@@jeremymachado2773 i figure out the problem. I replace my old terminal that goes to the battery and install new ones.
@jacoblichtenberg7442
Жыл бұрын
@@davidbautista9679the battery terminals?
@kunney1
2 жыл бұрын
my gen 3 motor keeps running had to pull fuse can you help
Пікірлер: 13