This is just a simple video on how to do a quick reset or calibration for an m-tronic stihl saw this one specifically is the 661c with a maxflow air filter and a west coast saw bark box.
I have photos of the manual steps at the end of the video if you want it from stihl themselves.
Warm saw for 1 min and shit off. Start saw without depressing throttle for 30 seconds and no more than 60 seconds. Then after that hold throttle for 30 seconds while saw calibrates and changes rpm based on the attached graph at end of video. After the saw drops down in throttle by itself after the hard climb of rpm shut the saw off and now your 661c is calibrated.
Негізгі бет Stihl chainsaw 661c carb calibration(M-Tronic reset)
Пікірлер: 1