This is by far the best method for gaining full adjustability on those carbs. Thanks for the stellar video
@richardflagg3084
Жыл бұрын
Great explanation. Honestly I never realized there was a 2mm allen head in there. I've always drilled them out. Yes, those pins are hardened, and occasionally the bit will drift. Going forward I'll be doing it your way. Much cleaner. Thanks Brennan.
@j.chrisbeck7492
Жыл бұрын
Thank you for that information, it may come in handy, I have the MS271, but I have not found the need to make any adjustments beyond the limits
@demetriogranados3879
22 күн бұрын
Thank you for this video
@jerseyjoshua4818
Жыл бұрын
A wise man, giving away free knowledge.... is a good man! Just my worthless 2¢
@tazman-kennyfuller
7 ай бұрын
Thank you Brennan. You rock. 🌲❤️🌲👊🪓
@stevemcdowell2019
7 ай бұрын
Again Brennan, you the man!
@mooregoodink7734
3 ай бұрын
Brennan, Thank you for this valuable information. Your kindness is much appreciated. I aligned each little groove with its corresponding limiting ball as you suggested, marked the center of each ball with an automatic center punch and using a 3/32in drill bit carefully drilled them out. It's difficult to see how the manufacturer gained an advantage by altering the carburetor in this way as the internals were caked with dirt.
@cottydry
25 күн бұрын
Excellent process for making this carb fully adjustable. What would be your suggestion for how many turns out on each adjustment screw to get started with. One turn on each????
@brennancass3747
25 күн бұрын
@@cottydry I usually start at 1.5 and adjust from there.
@eloytellez7319
Ай бұрын
Una pregunta por se trava el ahogador de motosierra STIHL ms 291 yno funsiona se aselera todo
@chrisbiltoc456
10 ай бұрын
This is the best way to do it. TY
@justinweaver8107
Жыл бұрын
That is ridiculous how they made those so hard to adjust.
@ClintsHobbiesDIY
Жыл бұрын
Good to know even though I don't have any of those models.
@G-PA-2795
Жыл бұрын
Good info Brennan
@larchman4327
8 ай бұрын
Got your saw to start smoking. My plug too clean worries me.
@Super-Dave-Outdoors
Жыл бұрын
I ground a slot through the pin with zip wheel on the one i did. Didnt know about the allen trick.
@jjm3254
Жыл бұрын
Great tip. Thanks.
@jonathanglanville7953
Жыл бұрын
When I tried to back out the adjuster like you showed, it ended up breaking the plastic piece that you showed in the beginning of the video. Any tips?
@TheKppus
11 ай бұрын
Tnx man !
@toddjacobs5660
9 ай бұрын
I just drilled my ms271 carb plugs out today with a 5/32" bit, it drills easy its just aluminum, i adjusted it better than when i bought it new, my low idle was too lean ...
Пікірлер: 21