Keep teaching and we keep learning Safety is the most critical thing to learn 😊
@RayofallTrades
10 ай бұрын
Absolutely true. Thanks!
@philliphall5198
10 ай бұрын
In West Texas we cut during spring and fall, with out the sap in the trees it will eat the chain, Misquite is hard wood type and very tuff Snakes are a very big concern here and common to shot 2/4 every year Thanks for the advice and information 😊 God Bless America, Ukraine and Israel ❤
@RayofallTrades
10 ай бұрын
I didn't know that. Thanks! Amen!
@Rusty-r3m
5 ай бұрын
It's a mystery even unto me!
@RayofallTrades
5 ай бұрын
Lol
@iromeolust5236
2 жыл бұрын
hi there I liked and subscribe as well. I learned a few by watching your channel I don't know much about my Stihl 14" chainsaw. but it has the same problem. I replaced the chain as was cutting a palm tree I nipped a rock and so it caused my chain to slip. now I replaced my chain with a Ryobi 14" chain that I bought from homedepot but it's still loose even when I tightened it down.
@RayofallTrades
2 жыл бұрын
Thank you for watching and supporting. There is a part number on the bar with size information. The ryobi chain may have too many links. What model is the stihl? MS170? MS210?
@Rusty-r3m
5 ай бұрын
Did it fix it?
@RayofallTrades
5 ай бұрын
Yes it did.
@Rusty-r3m
5 ай бұрын
Appreciate it.
@RayofallTrades
5 ай бұрын
@@Rusty-r3mI appreciate you watching!
@HouseMastersTools
2 жыл бұрын
Bravo 🍻
@RayofallTrades
2 жыл бұрын
Thank you for tuning in!
@exploitallowed695
10 ай бұрын
same problem on stihl 211 with new chain and new bar
@RayofallTrades
10 ай бұрын
It's a common problem. I usually make sure the drum sprocket matches the new chain too since that's easy to have wrong. Thanks for watching!
@exploitallowed695
10 ай бұрын
@@RayofallTrades it matches but the chain gets stuck in that sproket only 1 part , i am runing with thinn oil .. maybe thats the problem ,and i have another problem ,the idle screw doesn't do anything with new stihll carb
@RayofallTrades
10 ай бұрын
If the idle screw is moving the throttle plate, then it's probably the mixture is off or vacuum leak. For the chain, see if the driver links are chewed up from the chain jumping. I have also seen bad nose sprockets on brand new bars
@exploitallowed695
10 ай бұрын
@@RayofallTrades ok i ve did some diagnosis and saw that the acceleration wire is a little of and it doesn t let the chainsaw calm down
Пікірлер: 21