How to make a stoker, the step by step and suggestions for its construction.
Firewood stove for outdoor.
The project is made with a 10 mm thick flat sheet purchased from the scrapyard.
The upper mouth is 48 x 48 cm.
The base where the fire rests is 29 x 29 cm.
The side forms a trapezoid with a short side 29 cm, long side 49 cm and height 13 cm.
The height from the base to the floor is 9 cm.
The legs and sides have a 30 degree inclination.
Place a small base on each leg to prevent it from getting buried; when used outside.
The 10 mm thick sheet metal achieves a strong structure, which does not deform with temperature and does not degrade over time.
The sides have an inclination of 30 degrees from the vertical or 60 degrees from the horizontal.
The welds were made with 2.5 mm blue head electrodes and a current of 60 A.
The flat was bought in junkyard, to lower costs.
Any consultation that they want to do for their construction or advice is welcome; and do not hesitate to write in comments.
Square stoker.
Iron stove.
Square outdoor stove.
The best fire pit for the outside.
Firewood stoker model.
Spit, blacksmith, metal stoker.
How to make a good fireman with iron.
How to make and build an experienced fire pit to make roasts.
How to build a firewood stoker.
This is how a real metal stoker is made, with a 10 mm thick flat.
This is how the true iron stoker is made.
Негізгі бет Stoker. How I made my stoker with a 10mm flat. 🔥 IRON FIREPLACE 🔥
Пікірлер: 12