горячий клей разогреваю Горячим воздушным пистолетом,и сажаю деталь для гравировки,снимаю оставив в морозилке,или нагревая поновому и снимая,остатки клея удаляю,подручными средствами.I warm up the hot glue with a hot air gun, and plant the part for engraving, take it off, leave it in the freezer, or heat it up again and take it off, remove the glue residue with improvised means.
@SuperDutchman59
10 ай бұрын
держу в основном левой ногой,правая на педали,вполне хватает для нормальной работы=I hold it mainly with my left foot, the right one on the pedals, it is quite enough for normal operation
@SuperDutchman59
9 ай бұрын
уменшил рычаг поднятия тисков,наполовину,но перед этим нарезал резьбу М9,теперь рычаг выступает 1,2 см от тиск,резьба нарезана длиной 2,5 см.=====I reduced the vise lifting lever by half, but before that I cut the M9 thread, now the lever protrudes 1.2 cm from the vise, the thread is cut 2.5 cm long.
@SuperDutchman59
9 ай бұрын
при работе с золотом или серебром,шьем покрывало с маленким кругом посредине и от него вшиваем замок на край покрывала,для сбора драгоценной стружки,радиус полный 2 метра,ткань должна быть скользкая,типа клеенки на стол,или полиэтилен который можно шить,или на крайний случай простилаем толстый полиэтилен.======when working with gold or silver, we sew a bedspread with a small circle in the middle and from it we sew a lock onto the edge of the bedspread, to collect precious chips, the radius is full 2 meters, the fabric should be slippery, such as oilcloth on the table, or polyethylene that can be sewn, or on extreme case, let's lay out thick polyethylene.
Пікірлер: 5