I did the same thing. But I fill my tanks up with water.
@georgelehman4970
5 ай бұрын
i measured from the driveway to bottom of axle its 7.25 I had a thought maybe I could put a extra axle u bolts and plate the and just have them just a little tight so the flat plate is at the bottom of axles they are only like 4 inches wide and then put jack under that flat plate just to distribute some of the pressure of the jack
@LightUp2020
4 күн бұрын
Use a torch
@georgelehman4970
5 ай бұрын
What is the purpose of using the chains rapped around both sides of axle like you showed in part 2?
@davidtinkers
5 ай бұрын
That area remained bent after the previous work.
@georgelehman4970
5 ай бұрын
What size boards did you use a 4x4 or 6x6 ? one of my front axles are bent the top is leaning in a little i had a thought of using like 3 or 4 mufflers clamps on the bottom of axle to hopefully keep the axle from crushing in and use the boards like you have yours i do have a 3 ton jack on wheels but by the time you put jacks and 6x6 or 4x4s under it i think I would have to have trailer really high what's your thought ?
@davidtinkers
5 ай бұрын
I used two beams that were about 4x6 inches.
@georgelehman4970
5 ай бұрын
Ok thanks going to try 4x4 with a 2x4 under the 4x4
@georgelehman4970
5 ай бұрын
Might try a bottle jack that way, maybe not so much space taken up
@georgelehman4970
5 ай бұрын
Did it do any damage to the leaf springs or the bolts that hold the leaf springs like bend them ?
@davidtinkers
5 ай бұрын
No
@georgelehman4970
5 ай бұрын
How did you tie chains down ?
@davidtinkers
5 ай бұрын
The chains are wrapped under the wood beams and over the axle
Пікірлер: 13