I fixed the same problem: I replaced the direction vane because magnet was completely rusty, then I adjusted the trimmers. There are 4 trimmers inside. 2 for sensitivity and 2 for direction (X and Y). Adjust sensitivity: Voltage should be from 1 to 3.5V according to direction, then adjust direction on display. Remember to repeat the software adjustment described on instruction manual too
@PillSharks
7 жыл бұрын
I've had problems with my log and depth ever since I've had it, turns off after a couple of hours and then comes back on after 5 or 10 minutes and the log stopped after about 10 months. Stupidly I fitted the Clipper wind so I had matching instruments and that's been a complete joke, wind never shows in the correct direction and wind speed is always incorrect. I'll be ripping all my NASA Clipper range out of my boat this year, I'm looking at the B&G range! You pay for what you get!
@mehmetatik9003
5 жыл бұрын
The problem is wind speed sensor (reads magnetic point in the spinning the wind cups) corrosion inside the masthead unit. There is no a fixing method. You need to replace whole masthead unit. Company has been started to isolate the unit pole with silicon sealer at the pole connection to the unit. I had the same problem and I opened up the unit and found the problem and ordered the new one. I hope it will work.
@banoasailing8872
4 жыл бұрын
Hello,It worked for you?I have this problem...
@RayThackeray
Жыл бұрын
My wind direction masthead pre-processing card had corroded and had to replace two out of four trimpots, but it is VERY difficult to adjust the four pots for an accurate reading as the factory warned. I got it working 360 degrees but still innacurate, so can only use it for relative, not absolute readings.
@mehmetatik9003
Жыл бұрын
With new one There is no problem since three years
@maxiu12345
8 жыл бұрын
Hi! I have same problem. Did You found out what was wrong? Thanks
Пікірлер: 10