THANK YOU. QuiteAlright: You are much better than Subaru Users Manual. My steps for Outback 2005: FIRST YOU HAVE TO ACTIVATE PROGRAMMING MODE Open and close the door. Plug the key in ignition. FAST. Turn the key 10x ON and OFF. FAST. Now turn the key ON. Key is ON - but the instrument panel went dark. Beep beep beep Open and close the door. YOU ARE IN PROGRAMMING MODE. If you do not feel that you are - do everything again. It took me at least 5 times, before computer accepted me as a friend. Don’t give up! NOW YOU HAVE TO INPUT THE 8-digit ID CODE OF YOUR REMOTE TRANSMITTER. Using lock/unlock button on the driver’s door. Fast. Input your digits first time. Then again - the second time. Beep beep beep System will Lock/Unlock all doors. That means System accepted the code of your Remote. Remove ignition key. FAST. Open and close the door. FAST. That's it. You just programmed new key fob to Subaru. If you feel that computer does not see you as a friend - you have to repeat the procedure. It took me maybe 5 times. That’s computers’ nature 😉 When you feel that you are computer’s friend, now test the new Transmitter. For me it didn’t work the first time; nor the second time. But eventually new Transmitter was able to Open/Close the door. That’s computers’ nature 😉 QuiteAlright: thank you again. GOOD JOB.
@QuiteAlright
3 ай бұрын
You're most welcome and thank you for adding to the video. I will PIN your comment to the top
@tacostarfish
8 ай бұрын
For anyone struggling with this it does in fact work and this is the correct procedure for these years. I used the same Amazon fob as he does with the same code. Some tips would be make sure the ignition is LEFT ON. I kept leaving it off after the 10 cycles. Don’t forget both door openings before and after the ignition cycles. When you did it correctly the locks will click to locked to confirm. After you can turn the key off. Wait 5 seconds and open the door.
@QuiteAlright
8 ай бұрын
Thanks for adding your comment to the video. It will help other people for sure
@Pr0FroBro
Жыл бұрын
Thank you! My girlfriend had lost her fob long ago and I wanted to get ones to surprise her, I was able to get them both programmed in about 5 minutes, kind of annoying process, but this video saved my life haha
@QuiteAlright
Жыл бұрын
No problem and thanks for watching :). I know it is kind of unusual process but it works
@khaaalan
Жыл бұрын
Awesome! Worked the first time in less than a minute. Thanks so much for the clear video and instructions.
@QuiteAlright
Жыл бұрын
Great to hear! Thanks for watching
@calvarychapelmountaincente6265
4 ай бұрын
This is the best video on reprogramming the remote that I have seen! Thank you so much for posting it😊
@QuiteAlright
4 ай бұрын
You are most welcome. Thanks for watching
@Dwaurk
Жыл бұрын
Figured on what I saved $5 is still getting out cheap for a key. Using this because the sellers link was no longer working. Perfect instructions and clear speech. Thank you.
@QuiteAlright
Жыл бұрын
Thank you for watching and supporting my channel :)
@viachy
Жыл бұрын
Thanks 🙏👍 the best tutorial for this purpose! Took me 5-6 tries, but I did it! I think that it's crucial to be quick with rotating the key. Once the car enters in programming mode you know, and only have to open and close the door again. Then you can take it slow with adding the digits. After you enter the code once the car lets you know! Then you add it one more time and you'll hear a locking sound! That's the confirmation that the new key is added. I actually messed up adding the code correctly the first time and had to try a few more times to enter in programming mode again... But now it's done. Thanks again
@QuiteAlright
Жыл бұрын
You are very welcome. I'm glad you were able to do it. It took me actually bunch of tries to record this video :)
@Vans4252
Жыл бұрын
I’m getting to the locking part after entering the code twice but they key fob still isn’t working. Not sure what’s wrong.
@DavidWolf84
2 жыл бұрын
Best video. Got it fast. Easier than other videos and online directions. Thank you!
@QuiteAlright
2 жыл бұрын
You're welcome!
@SlickEvan
10 ай бұрын
Thank you so much my guy. Just got myself a key fob off of Amazon and needed this.
@QuiteAlright
10 ай бұрын
No problem. Thanks for watching :)
@liamwalker1881
6 ай бұрын
You're a hero, thank you so much!!!
@QuiteAlright
6 ай бұрын
You're most welcome
@Ryan_Carder
Жыл бұрын
Wow that was a lot more complicated than it needed to be, Su aru 😅 Thanks for the video!
@QuiteAlright
Жыл бұрын
No problem. Thanks for watching
@59steveo
2 жыл бұрын
Thanks. Worked the first time
@QuiteAlright
2 жыл бұрын
You're welcome!
@officialobeythealtarnative9779
6 ай бұрын
Worked great... Thank you
@QuiteAlright
6 ай бұрын
You're welcome!
@Rogeriorhein
5 ай бұрын
You’re the best ❤
@QuiteAlright
5 ай бұрын
Thanks
@larrytreichel9045
Жыл бұрын
Note; if you have a manual shift, you will need to press in the clutch to enter the programing mode
@QuiteAlright
Жыл бұрын
Thanks for the comment
@johnjoe9918
Жыл бұрын
I have a manual. I have a jumper wire in the harness that plugs into that neutral switch on the clutch pedal so I can start the car without the clutch being pressed in as I will be hooking up remote start before the winter. I have followed all the programming steps over 10 times and the beeps and lights blink and everything like it should but when I press any button on the remote it doesn’t do anything
@coltenthiel4563
Жыл бұрын
Awesome, worked like a charm!
@QuiteAlright
Жыл бұрын
Great to hear!
@Vans4252
11 ай бұрын
Thanks! Just got it to work!!!
@QuiteAlright
11 ай бұрын
You're welcome. I'm glad it worked out for you
@kramicakhurana7744
2 күн бұрын
I am unable to program it even though I entered in the programming mode with beeps
@valsimonovich1471
Жыл бұрын
Thank you. Worked for me
@QuiteAlright
Жыл бұрын
You're welcome. Glad to hear that
@johnjoe9918
Жыл бұрын
Why didn’t your doors cycle the locks when you confirmed the code? Every other video I watch of this you can hear the locks lock and unlock
@tigger126
6 ай бұрын
08 Outbacks have integrated key/fobs
@adamgrube454
Жыл бұрын
It works. Thank you.
@QuiteAlright
Жыл бұрын
You're welcome!
@MelonLord11
Ай бұрын
I don’t get like a beep that my car is in programming mode
@user-ok1xr1ww9c
Жыл бұрын
So his remote number is the same as mine????? Haven't been able to get mine to work. Trying so many times my lock/unlock button stops working. WTF
@officialobeythealtarnative9779
6 ай бұрын
I was able to program one remote with no problem... But I have another fob with a different code and it won't let me complete the sequence before th doors start locking. Is there another step for programming two fobs for one car?
@QuiteAlright
6 ай бұрын
Hi, sorry to hear you are having problems. I'm not familiar with other way to program the fobs, maybe try calling the dealer and see if they would test the fob for you for free
@hubercats
Жыл бұрын
Thank you!
@QuiteAlright
Жыл бұрын
You bet!
@ProPhoto-rc7yn
Жыл бұрын
Great instructions! Would you by any chance know how to program remote on 2012 Subaru XV? Kind Regards
@QuiteAlright
Жыл бұрын
Thanks. Unfortunately I've never done it on Subaru XV. Sorry I can't help more
@corycaulk2630
Жыл бұрын
Thanks!
@QuiteAlright
Жыл бұрын
No problem and thank you. I appreciate your support
@ronrec2633
Жыл бұрын
Do you have a link to the key fob you used?
@QuiteAlright
Жыл бұрын
What is usually do to get the right key fob for any vehicle: 1. Call Dealer with vehicle VIN number and asking for the quote on the key fob and asking for part # 2. I cross reference the part # online and see which key fob exactly I need 3. Then I buy where is the cheapest (usually amazon or ebay)
@suhailksa5358
2 жыл бұрын
where i can find the codes if i lost all keys
@QuiteAlright
2 жыл бұрын
New key fobs will come with codes. You can get those cheap online. Or you can try calling the Subaru dealer with your VIN number, they might be able to help you out
@panamerykan9262
3 ай бұрын
@@QuiteAlright Yeah ... Subaru dealer is the way to go for new Key / Remote. Provided that you do NOT see better ways to spend your $250 ;-)
Пікірлер: 60