I have been slowly collecting scrap steel to build myself WELD TABLE 2.0
I knew I wanted a minimum top thickness of 3/4" and workspace of 4'x7'...anything less would be a downgrade from the old table.
There were a couple features I wanted to upgrade from my old table:
Unclutter the under-table storage and keep it simple and easy to clean
More clamp storage
Heavier duty clamping capacity
Flatter work top than my old table
RECLAIMED: (total cost less than $100)
The I-beams and pipe remnants came from a local steel building erector
The 3/4" plate came from a local farm
The 3/4 square bar stock came from a trucking company
The expanded mesh, small pipe & box tube were remnants from my shop
NEW: (Cost $265)
The 3/4 X 6" flat bar was bought new.
RIP grinder
#weldingtable #weldingprojects #DIYweldingtable
Негізгі бет Тәжірибелік нұсқаулар және стиль Super FLAT homemade welding table | DIY
Пікірлер: 97