Full install and tips video for my new Supermiata high torque clutch and light flywheel. This is a great clutch if you've gone turbo in your Miata and need to handle way more torque than stock. The flywheel is close to 10 pounds lighter than stock and helps improve engine response.
Time codes for each step in the process:
1. Remove console and shifter 00:12
2. Lift the car 01:48
3. Unbolt the slave cylinder 02:15
4. Drop the splash tray 03:15
5. Undo brackets, speedo cable, wiring from trans 03:55
6. Drop the exhaust mid/down pipe 05:48
7. Remove cross member bar & drain trans fluid 06:30
8. Remove the drive shaft 07:30
9. Loosen power plant frame (PPF) 08:22
10. Support the back of the trans with a rope through the shifter hole 11:10
11. Setup for taking out bell housing bolts 11:30
12. Remove bell housing bolts 12:30
13. Support the front of the engine from the oil pan 14:10
14. Lower the transmission 15:00
15. Inspect the transmission & maybe clean 15:43
16. Remove the clutch and flywheel 17:00
17. Inspect and replace if needed the rear main seal and gaskets 17:20
18. Prepare the flywheel bolts (need sealant) 18:09
19. Install new pilot bearing in the flywheel (do it off the car!) 20:49
20. Install the flywheel 18:58
21. Setup new clutch/wipe down 22:10
22. Install the clutch and align 22:40
23. Install throw-out bearing, grease everything 24:20
24. Re-install the transmission 25:45
25. Apply anti-seize to PPF bolts and install the back one plus insert 26:46
26. Alignment method for the PPF front bolts 27:41
Straight edge should go across the car perpendicular to the PPF at the first bolt:
If measuring from the framerails, the edge should be 66mm +/- 5mm from the base of the PPF.
If measuring from the floor pan (your framerails are crushed like mine) measure 10mm +/- 5mm.
27. Re-install shifter (new gear oil in the turret) 28:41
Don't forget to refill the transmission with new fluid! 2 quarts of 75W90 transmission oil plus a half a quart for the turret/shifter.
Tools:
Normal stuff like a variety of sockets, 1/2 inch drive, 6 point is recommended.
24mm, 21mm, 17mm, 14mm, 12mm, 10mm.
Breaker bar: amzn.to/2uKbmBp
Transmission jack like I used: amzn.to/2Nfebkj
#namiata #miata #supermiata
OGPedxing is all about DIY, gadgets, and tools.
Негізгі бет Автокөліктер мен көлік құралдары SuperMiata Clutch Install!
Пікірлер: 30