Join this channel to get access to perks:
/ @tk.designs
In this video, I install the Shapeoko 5 Pro Sweepy Pro dust boot. This boot is different than the boot that comes with the machine, as it has a set height above the work piece, and allows the spindle to operate up and down independently.
I will show you how to install the dust boot, and then demonstrate it on the machine.
This dust boot is available through Carbide3D at the following link:
shop.carbide3d...
***NOTE: This video is not sponsored or endorsed by Carbide3D. Any opinions I offer are my own, and I have not received any form of compensation. I purchased this boot using my own funds.***
Please let me know in the comments if you enjoyed this video, and if can, take the time to look at some of my other videos. Thanks again for watching as always!
Disclaimer: TK Designs receives a small commission from sales of certain items. As an Amazon Associate, I earn from qualifying purchases. The buyer incurs no additional charges for products purchased. Thank you!
My favorite Bits:
SpeTool 5.2 degree .5mm radius Tapered Ballnose: amzn.to/3GnrdY0
Yonico 35310-SC 1/8" diameter 3 flute upcut endmill: amzn.to/3bEnlWW
Yonico 37310-SC Tapered Endmill: amzn.to/3Q8052A
Amana Tool 46280 1/64 Radius Tapered Ballnose: amzn.to/3gADMp7
Amana Tool 45611-K Tapered Endmill: amzn.to/3p6lnl2
SpeTool Down Cut 1/4" CNC Bit: amzn.to/3zGzOBi
Freud 25/64" Keyhole Bit: amzn.to/4b4kXBT
My Former CNC (replaced with Shapeoko 5 Pro):
Sainsmart Genmitsu PROVerXL 4030 CNC: amzn.to/3P6yFZD
Sainsmart Genmitsu 24" x 24" (600x600mm) XY-Axis Extension: amzn.to/3zCJaOw
Sainsmart Genmitsu T-Slot 6060 Aluminum Spoilboard: amzn.to/3p2dRYt
Негізгі бет Sweepy Pro Dust Boot Revolutionizes Shapeoko 5 Pro Experience!
Пікірлер: 4