They put the enguage and disengage sticker on backwards, love the mower. Nice video.
@jtassoni8765
8 ай бұрын
Good advice on the nuts, washers and bolts. I just brought mine home today. I think I will use a blue threadlocker during assembly and check factory bolts as well. Nice video!
@Anthony-nr1nd
Ай бұрын
I have a suggestion, using butterfly nuts is a great idea and will work good but I would suggest taking the bolts and drilling a small hole in them to make room for a medium size or small slide pin this way if they do loosen which they most likely will you can not have to worry about loosing the bolts or anything it will still stay in place and you can always tighten them up, I did that to a few of my projects and it turned out great and worry free! Putting thread locker on the threads over time will gum up the threads and it will cause them to no longer hold. I tried that too😅 the best thing was drilling the small hole and then putting a pin in it! Try it out!
@ferddoes1498
3 жыл бұрын
Thanks for the Video, I can say these are great , but he's right the bolts do come loose. I took the time to take them all off and used red lock tight on them and haven't had 1 come loose since
@romainebrown7249
Жыл бұрын
I have 6 acers of about the same and have been looking into this system versus a 4 wheel drive tractor and bush hog and I think this is the winner and cost affordable
@68ray
3 жыл бұрын
Thanks for the detailed information. Mine arrived today. Can’t wait to use it.
@AutoHoax
3 жыл бұрын
You can always use a large enough bolt that u could drill a hole perpendicular to the bolt and slip a cotter pin in the hole right above the wing nut so it can't vibrate completely loose.
@Redhackle
3 жыл бұрын
Thank you great video.
@OurNewLand
2 жыл бұрын
Hey man. Really good info here. Are you still happy with the mower? We are thinking of buying one. Thank you.
@epicletterr4048
2 жыл бұрын
Yes, still happy. Haven't had any issues apart from one tire popping off the rim. No tire damage...just popped it back on and reinflated and haven't had a problem since.
@OurNewLand
2 жыл бұрын
@@epicletterr4048 Thank you! We're going to place an order for one tomorrow.
@epicletterr4048
4 жыл бұрын
Updated video to allow comments.
@hilariogarza846
3 жыл бұрын
I’m considering the same ATV & 44 inch swisher. How wide is your 12ft trailer?
@scottnichols9759
3 жыл бұрын
They actually just put your sticker on backwards for the "Engaged - Disengaged"...mine's correct.
@johnclayton5691
2 жыл бұрын
I wish I had DR rough-cut mower. Instead, a couple months ago I purchased a Swisher brush mower which is 448 pounds and tires on the unit unable to carry the weight effectively. First time mowing and had a flat. Following day, noticed the other tire was half deflated. Also, drinks gasoline fast. Furthermore, raising and lowering and leveling machine complicated. One last thing, due to only two flimsy, small wheels to support mower; I found that scalping ground with mower blades happens on rough ground. My previous brush mower with four wheels mowed the same area and never ever scalped the ground.
Пікірлер: 20