Great ! Please do you have a video about practical applications for this synchronization of two servomotors ?
@francisgremillet3894
3 ай бұрын
Do almost the same after having choses servo drives and motors into the hardware configuration. If you want both motors start at the same time, activate the gear_in.execute bool before starting the master axis.
@vorapobautomation9760
3 ай бұрын
How to use tension control in Sinamics S120 ?
@madsvigan2898
4 ай бұрын
My simulator just chrashes
@francisgremillet3894
3 ай бұрын
Is your computer able to support axis simulation? Also consider using Siemens S7PLCSim Advanced software.
@madsvigan2898
3 ай бұрын
@@francisgremillet3894 i figure it out. Needed to change some cycle times in the OB blocks. Simulator just crash if it Was to low.
Пікірлер: 6