I've been a fan of "quarterwaves" for about 18 years now. Got tired of messing with Martin Kings formulas and spent many hours playing with simple lines and testing on LMS and RTA mics and learned everything I needed. But all my testings with strait, tapered, horn, iso, 4th 6th order, passive radiator coupled, M horn etc, my favorite has been the 4th order Quarterwave- hands down. I'm currently working on my comp car 2-18s in a 4th order quarterwave the line is 30-31hz long but I should be peaking around 20 Hz for my particular install and comp class.
@BudgetBassHead
4 жыл бұрын
Wow. That sounds amazing 😀 any links to the build?
@williamtoth6186
6 жыл бұрын
Good info! That's the steps I used to figure out my jl tline.
@cekpi7
6 жыл бұрын
Nice, makes things easier.
@trinithings5384
6 жыл бұрын
Nice video Love it
@tenskeeze
6 жыл бұрын
#voice of Steve Harvey Nice video keep em up bro 👍👍👍
@Rendraco79
6 жыл бұрын
Nice video Greetings from Colombia.
@jessicaembers924
5 ай бұрын
I'd like to see a 6th order tapered dual transmission line.
@Mirabove_DK
5 жыл бұрын
What about the "camber" right behind the driver, how do You calculate that, or should it "just" be as small as possible ???
@traquisbunting3257
3 жыл бұрын
Thanks for this video I understand a lot more now. My question though is with the design that you chose I will be using 2 12 in subwoofers. How does the math go in my case?
@tlinedesigns9728
5 жыл бұрын
If you want any help with t lines shoot me a message I've built 36 not claiming I'm a boss or anything but I like helping and learning ps you can get huge output out of a 12 tuned to 30 as far as a t line and still dig to 20 or 25 depending on the sub
@sanjayheaven5230
4 жыл бұрын
could you help me?
@kylepowell3068
4 жыл бұрын
Hey bro I'm having difficulty getting a good bandpass for my 15 mojo615d4 it hits low well then drops out and picks back up in higher frequency kind of like 2 mountains on the frequency graph. Not sure if width of port is off length is off or both? Any help would be great
@Strobe_rockets_
27 күн бұрын
I need some help bro cab u do a multi sub t line let's say 3 8s any help will be appreciated
@rodrigolopez9710
Ай бұрын
MI PREGUNTA USTED NO LE SUMA AL VAS O VOLUMEN DE LA CAJA LAS TABLAS O MADERA DEL PUERTO O PORT PORQUE OCUPAN ESPACIO ADENTRO DEL LA CAJA CUÁNTOS LITROS OCUPAN Y LA PARTE TRASERA DEL ALTAVOZ OCUPA ESPACIO USTED NUNCA HA COMENTADO SOBRE ESO
@brianscheimann4876
5 ай бұрын
If using two drivers, does the Sd double or do you only have to calculate for one driver? Also, do you have to use the recommended air space for the driver?
@BudgetBassHead
5 ай бұрын
Yes and no. SD doubles
@alfa7108
6 жыл бұрын
good vid thanks
@shawnbrooks8271
2 жыл бұрын
Thank you for the video, my name is Shawn, question, is a folded horn the same as a t-line as far as fz range. I want to build either folded horn or t-line to cover midbass fz's ~80-400 range. Or am I way off track with that plan. I've got plenty of room in my van and dsp great amps to do the job.
@kennypacheco13
2 жыл бұрын
So on my skat evl 18 the sd is 1164.1 cm2 and the port area is 55.5inch2. If you do the math 1164.1cm2 to inch2 is 180.436? I’m confused
@timtations_
3 жыл бұрын
Im a little lost on using the cut out measurement for part of the equation? Any help would by greatly appreciated
@xxmeanyheadxx
3 жыл бұрын
Yeeaahh babyyy!
@j121212100
3 жыл бұрын
great channel!
@BudgetBassHead
3 жыл бұрын
Thanks for the visit
@bujoun76
5 жыл бұрын
If I use more than one woofer does that mean I will need to add up all of the radiating surfaces to determine the "line area"! I am thinking about building a TL tower with 8 four inch drivers and a tweeter. Or should Just port the thing..?
@BudgetBassHead
5 жыл бұрын
That's correct.
@bujoun76
5 жыл бұрын
Then port it is! Thank you. And thanks for responding so quickly. That is not exactly normal here on KZitem.
@ajmann07
4 жыл бұрын
With a Mounting depth of 5 how did you offset the Sub ? (Spacer or a total front covering) and if using a covering did u add the 1/2-3/4 thickness to your total line length? Also does the line length start at the Subs center line or the inside edge of the starting point to the exit port ? Good explanation of the T-Line and your videos are Bad A#$
@BudgetBassHead
3 жыл бұрын
Here is the build: kzitem.info/news/bejne/tZlqqomfgadhiqg
@Andrea.Gandalf
5 жыл бұрын
very interesting video, I wanted to know if you have ever done tests with the transmission system of wisdom audio? is a new system that as they say those of wisdom audio is revolutionary, what do you think? I heard the s90i model and impressed me with the sound pressure !!
@BudgetBassHead
5 жыл бұрын
Never heard of them. I'll look them up.
@robkeyo8029
5 ай бұрын
Ok,, I built a T, LINE. It actually works!! 4th order,, I got it down to ,, now no joke,, 10, HERTZ!!! with my 8 in woof.
@BudgetBassHead
4 ай бұрын
Congrats, no turning back now 😄
@Strobe_rockets_
24 күн бұрын
Is it possible to do a t-line with 3 8s.......got sundowns x v3
@trecedaves3159
5 жыл бұрын
Forgot to say speed of sound changes in elevation but close enough. Lol
@J4NK3Y
4 жыл бұрын
does damping material a difference in speed of sound as well ? or whats the difference to acoustic foam ?
@TheRattleSnake3145
5 жыл бұрын
Should also have 45's in the corners.
@1WildDragon
4 жыл бұрын
do you start your measurements from the center of the speaker or at the edge of the first chamber?
@adolphjanssen6580
4 жыл бұрын
Hi guys, the first design with the 2 speakers one in the sealed section and one in the ported section, Now do these speakers work in phase or out off phase. I would think out off phase. If both speaker cones move forward they will cancel each other out. So the sealed speaker moves forward and the port speaker moves back, then the pressure wave rolls out off the port. Please please can somebody comment on this. Thanks so much.
@BudgetBassHead
4 жыл бұрын
They would definitely have to work out of phase
@Durolith
3 жыл бұрын
transmission align the port with the FS of the driver meaning they both move the same space of air forward in Sync which add 3db over a ported enclosure, your middle desing isnt T-Line
@gabrielc2644
5 жыл бұрын
Does the tune only rely on the subwoofers fs?
@BudgetBassHead
4 жыл бұрын
T-Lines are a bit Different than most builds. But no, It depends on many parameters. As many of them are contingent upon each other.
@KnowName33
4 жыл бұрын
Damn my sub has a mounting depth of 10.6"
@gregblau8082
3 жыл бұрын
So is the response where it starts to roll off or something like 3db down?
@BudgetBassHead
3 жыл бұрын
Transmission line speakers roll off at 6db per octave from the tuned frequency of the enclosure, bass reflex designs roll of at 12 db per octave.
@Triple88a
4 жыл бұрын
Sooo why go with a 1/4 wave length rather than say 1/2 which would be exactly inverted?
@BudgetBassHead
4 жыл бұрын
It's just the formula I was introduced to. No preference other the others.
@mansurdaghbas563
3 жыл бұрын
love the channel very helpfull and informative! need a little extra help if you would? im always trying to get a little more out it you know what i mean!? my so and i built my truck with audio video and lighting as the main foucus! we plan on having fun and doing some shows! he loves music and and music production and hes only 9 already a bass head! so we did a blow through 6th order in a 2006 f150 super crew with the four full doors. what we used dont get me wrong it sounds fantastic! but like i said a little more! Subwoofers (4 )Sundown Audio Sa8s v3 box ratio is 1-1 tuned at 36 hz and 61hz Subwoofer Amp Stetsom 9k EQ (Amp is bad A,.........!) Mids &. Highs (4 )6 &n 1/2 kicker components (Planning on doubling these) Mid and high amp Stetsom so after watching this video i thought about a build for the truck did all the math but i doont know what the end result of the boxes tunnhimg would be? I tried to down load that win program for building box but it dosnt work for mac and thne other recomended onhe for mac was giving me issues, so i just did the math work if i figure out how to post piuc of box designs id likje some input please!??
@BudgetBassHead
3 жыл бұрын
The t-line running is that of is fs. What's more important, is total come area to determine line length.
@crazyexperiments4815
4 жыл бұрын
I've built a T-Line enclosure for a 6,5" sub using this formula and it sounds great at low/medium volume but at higher volumes when the sub gets to move, a lot of turbulence starts to occurs at the port. Any idea of what causes this?
@BudgetBassHead
4 жыл бұрын
did you put 45 degree angles in your enclosure corners to assist with air flow? The final bend of the line it's critical that you do this. Also, place some acoustic dampening material in the line, preferably in the beginning of the line, it helps dramatically with resonance and air flow.
@crazyexperiments4815
4 жыл бұрын
@@BudgetBassHead yes, I've put angles in every corner so the port should have the same area all the way through. I don't have any dampening inside tho, might it try that. Thanks for response
@crazyexperiments4815
4 жыл бұрын
@@BudgetBassHead You can hear it a bit when the door is open - kzitem.info/news/bejne/mKCA2nWhcIuppqg
@matthewmattson6881
2 жыл бұрын
@@crazyexperiments4815 I trust you did the math right but try increasing the surface area of the port a little bit. It may lower the velocity of the air exiting it, reducing the "chuffing" sound
@megganlogan5593
5 жыл бұрын
Big d I need a t-line 4 a qw3 12 gothic going on a planet audio 2.5k torque amp I want one tuned to bout 35hz
@salamnazar7481
6 жыл бұрын
dear sir do you have any plan design for tower speaker box 3 way
@BudgetBassHead
6 жыл бұрын
I have a video coming soon on that design.
@JMHGlass
5 жыл бұрын
What ever happened to this build? How did it turn out?
@makskoma
3 жыл бұрын
343÷hz÷4=lengh of port Port 50% bigger then sub square feet area Thats all
@TheRattleSnake3145
5 жыл бұрын
The first 3.5 mins of the video could have been removed. There was no reason for it. Other then that,the vid was good
@gianstevens7918
6 жыл бұрын
The human ear can't hear anything below 20hz anyways, it's physically impossible. So bass under 20 is always just felt, the only thing you would hear is port noise or the driver itsself.
@kevindamen5563
5 жыл бұрын
Gian Stevens zeker waar🙈
@vladlu6362
4 жыл бұрын
Actually, people CAN hear below 20hz. Just not everybody. 20hz is an average.
Пікірлер: 66