Thank you very much for the clear and precise instructions. Did everything the same way. The next step is to replace the controller according your recommendation.
@markgrace2759
5 жыл бұрын
Wow nice piece of hardware. Well built and put together and also presented superbly.
@wallacew8634
4 жыл бұрын
I have one of these and made several good quality boards 3+ years back. I'm making a new set of double sided boards and did some research on the subject and found many new updates and posts for this machine. I have since run some data logging on my machine and found that I can just modify the curves to match the actual temperatures I want. Other than the debounce issue, my machine seems fine. I looked at the tape inside and it is all well away from the heat and shows no signs of degradation at all. If I had to make a mod, it would be to add thermocouples at board height. A couple of flying leads from the board to plugs in the side of the cabinet would do the job. Any comments on this?
Пікірлер: 4