Thanks for the video, I had thought about buying one of these a few years ago, now that I have to change my water heater, it will help me a lot. Thank you again.
@Matts_Crafty
2 жыл бұрын
I have been using one of these for HVAC and water heaters for years. I also have the 1k lb lift as well but def over kill and way to heavy unless you have a lift gate. Good video this will def save someone’s back.
@mikekmalick
2 жыл бұрын
I am not a plumber but was a general contractor and a builder for 40+ years. I am replacing my gas water heater tomorrow and I am going to convert my floor jack into a temporary lift be bolting a 2'x2,' 1-1/8" ply to jack. **My question for you is how do you get the aluminum pan under water heater without damaging it?**
@johnphillipsplumbing7148
2 жыл бұрын
Thanks for the question, I use my lift gate to position the water heater higher than the pan and carefully slide the heater into the pan,and then I slide the pan with the heater in it onto the stand ,carefully. Best to have two people if you can,I hope that helps you.
Пікірлер: 5