Next time, use a good sealer, and it would be all right. You could’ve just used the same Gearbox. Sealers called the right stuff. All you had to do is clean the oil out of thread it in what have been fine.
@ZZZZZZZayac
7 ай бұрын
Does the instruction manual contain information about the tightening torque of all screws? Where can I find this out?
@MathewTavares
7 ай бұрын
Should be on the talaria website
@ZZZZZZZayac
7 ай бұрын
@@MathewTavares I would appreciate a link to this.
@@ZZZZZZZayac actually this one is better www.reddit.com/r/Talaria/comments/vz3fq6/talaria_sting_torque_specs/?rdt=58559
@ZZZZZZZayac
7 ай бұрын
@@MathewTavares Unfortunately, this instruction manual does not contain a word about screw tightening torques.
@harrybauer7904
4 ай бұрын
Fuck! The same thing just happened to me. That looks like a huge pain... I got mine semi-tight, hoping it doesn't leak and I can just run it. I'm curious if it's possible to just remove that cover instead of replacing the entire box..or even just tapping it one size bigger? Any thoughts? Thanks for the video.
@MathewTavares
3 ай бұрын
Yes you can remove the cover if you have it but when we went to search there was only a whole assemble only in stock so we had to go that route !
@zaccole2387
9 ай бұрын
in crocs is crazy
@MathewTavares
9 ай бұрын
🤣🤣🤣🤣 my b
@Woodywater
3 ай бұрын
Definitely not talking any crap but that was way more difficult than just removing the motor with the gearbox attached to it. Be done in like two hours.
Пікірлер: 13