Funny, I got the same motor and bike and the sensor looks different.
@TwoThreadsAhead
Жыл бұрын
Very informative and helpful video! Also likely an eye opener and note worthy consideration for anyone thinking about buying one.
@kevinwiebe6846
23 күн бұрын
Where can I find this part?
@pivkaaa
2 ай бұрын
Does someone know where is the "match" option on the L1E?
@bundy9026
Жыл бұрын
You guys should do Sur Ron hall sensor next
@SonnyYoung-s3s
2 ай бұрын
I have error code 00 anyone got an idea how to solve this problem
@skykr2932
Жыл бұрын
Great video but would love to see how to do this on the TL3000 as the hull sensor is a bit different and is not as modular than the TL4000.
@JoshuaToal-hz9mt
Жыл бұрын
Hi mate did you ever find out how to do this on the original talaria? I would love to no how to calibrate it!
@skykr2932
Жыл бұрын
@JoshuaToal-hz9mt nah mate had to replace the full motor because my sensor was cracked and I could not get the new sensor perfectly aligned
@vbrxd8822
Жыл бұрын
My sting mx-3 just thrown up the same code is it easier just to replace the full temp sensor?
@lunacyclerepair
Жыл бұрын
It is easier to do this if its just a pinched wire..if its not a pinched wire then replacing the temp sensor will be the next try.
@igrik4530
Жыл бұрын
@@lunacyclerepair Hi dear, i have the TALARIA MX3 Street Legal (TL3000) and has this problem : after a little fall the speed indication on the Displays show the speed with litlle delay, i can start rolling 2-3 km/h but its shows 0 km/h after i get faster its start to shows the speed indication with delay, what can be the reason and how to fix that ? i also have this Match setting but after i start matching it shows me matching fail after 30 seconds
@LuckyO97
Жыл бұрын
So I got the mx4 from you guys, does this happen a lot? And is this bike already messed up or are you just showing how to?
@Idgaf69
Жыл бұрын
Good question lol
@JoshuaToal-hz9mt
Жыл бұрын
How do I calibrate the hall sensor on the original talaria sting?
@toddbraun
3 ай бұрын
I am getting a reading on my EBMX controller of -182 degrees. Is this an indication of a temp sensor problem?
Пікірлер: 16