to take the tension READING ? you can use a hanging scale but that requires taking the reading from a different spot and compensating for the fulcrum and it gets complicated .
@TATTOOTRAINING
11 жыл бұрын
no splatter, no tube riding , thats the whole reason he was sticking it out , has a slanted diamond tip as it was , told him to make the stroke a tad longer and not stick It out as much ,
@northerncali707ave
11 жыл бұрын
Very helpful video!!!! Thank you it answered alot of questions. Is there anything else besides the tension gauge that works the same to take tension of the rear spring?
@TATTOOTRAINING
11 жыл бұрын
it depends on the tension 20 rear is high tension an d16 front is low BAD combo it will make the front flex allot give fucked up duty #
@TATTOOTRAINING
11 жыл бұрын
a spring tension gauge
@northerncali707ave
11 жыл бұрын
Ok thank you for your reply and info! Will you be getting into building machines again by any chance?
@TATTOOTRAINING
11 жыл бұрын
went over that in a private message with him , he didn't think so but I would say most likely he was sticking it out too much . probably wasn't getting good ink flow either
@TheGixxer6969
11 жыл бұрын
on my liner i have a 16 and 20 is that good thanks
@fLa5hNYV
11 жыл бұрын
What is that thing your using to measure the tension of the machine ?
Пікірлер: 10