Never use rubber gasket glue on surfaces dealing with oil under high pressure, or areas where oil has to drain. Pro tip from the trade mate. But your doing good mate, keep it up.
@saz4x435
4 жыл бұрын
Thanks for the advice mate, appreciate it 👍
@skippy2987
3 жыл бұрын
As a general rule internal wastegates on factory turbos aren't very high flowing and are marginal with a big exhaust. Good attention to detail with a die grinder on the turbine housing, particularly in the entry to the wastegate (and making the wastegate hole bigger if your turbine housing was a cheapy with a hole that's way too small for the flapper) will *usually* solve this without the need for an external gate. There are more than a few other stunts you can pull with the grinder but they are usually for when you're using a turbo a bit too small for the application. A GT3582 isn't too small for any legitimate road use though...
@reddo84
3 жыл бұрын
Your really doing well mate. The music choice is really good, and it match’s what’s happening in the clip. Keep going, and keep the content coming along.
@andreastourogiannis1544
Жыл бұрын
Hey mate, been working on my GU turbo project. Are you able to share a photo of where you took the supply oil feed line for the turbo?
@marekbusta2mordy-silver-po292
4 жыл бұрын
Perfect video mate! Hail from Czechia! ❤️ Every type of Patrols from G60 to present Y62 V8 S5.
@saz4x435
4 жыл бұрын
Thank you mate, I appreciate the support!
@dionsutton9986
4 жыл бұрын
Sick setup mate 👌 got similar done in my Gu wanna see what numbers yours is running in next vid
@danielr9154
4 жыл бұрын
Cracka video! Maybe do a video towing the Datsun 1600 haha
@saz4x435
4 жыл бұрын
Hahaha will do, just tell me when hahah
@Sco33a101
Жыл бұрын
Any chance you have a turbo install video, with a how to on the oil catch can an so on?
@gazwalton2512
4 жыл бұрын
Do you have a build spec and what you needed to do? I was thinking LS swap but a TB45 turbo seems to be cheaper and to be honest cooler hahah
@saz4x435
4 жыл бұрын
I have a video coming out in the next couple of weeks where I run through how I have done the entire turbo setup, so keep an eye out for that. I myself was deciding the same think before I started the build and I went for turbo because it has the potential to make more power than a stock LS and it is simpler to do and cheaper.
@cameronmcdermott4354
10 ай бұрын
Hey mate, did you have to get it tuned? What was the cost
@VCTR2009
Жыл бұрын
Hey guys! Where are You from?
@dandelao9653
2 жыл бұрын
where did you get the turbo kit that you intalled in your tb45?
@TheJanope13
4 жыл бұрын
did you buy the gu already turboed? How did you go about engine management for the turbo? nice vid btw (Y). Edit: nvm i heard you say haltech ecu. Jeez it would've been a pretty penny to set that up. On your Ps too mate ;) haha
@saz4x435
4 жыл бұрын
Haha wasn’t cheap, I installed the turbo setup from scratch, but I didn’t film it, thanks for the support!
Пікірлер: 20