Certainly a work closer to the perfection that I have seen, congratulations to the team, and I would like you to answer me, do you use how many sensors for gaap identification and what is your logic? I'm sorry, my English, I'm Brazilian.
@skrima5376
4 жыл бұрын
We used the 3 light sensors from line following to identify the gap. There is a gap, when all 3 sensors where on white for a specific amount of time
@endrylryan9777
5 жыл бұрын
OLÁ, EU GOSTARIA MUITO DE SABER QUAL O NOME DO SENSORES QUE VOCES USAM PARA INDENTIFICAR A COR VERDE!!! AGRADECIDO
@aekkaratwongchalee23
5 жыл бұрын
How to write a program to work in line and turn to turn green when it comes 2 sensors or 3
@jonasbrito431
5 жыл бұрын
Hello!! I wish I could receive instructions for assembling your project. I'm from Brazil and I work with competitions. please get in touch.
@maryamsaeidhadial-saadi4765
2 жыл бұрын
how did you make it avoid the obstacles?
@luisreyes231
6 жыл бұрын
Hi good work I have some questions about you robot, how I can contact with you ?
@DhanLaagan
6 жыл бұрын
What type of sensors did you use?
@Leeeegyu
4 жыл бұрын
Hello, how did you measure that the green part?
@skrima5376
4 жыл бұрын
We have a color sensor on each side of the robot to detect
@aarravoltics4592
4 жыл бұрын
Very nice have you used arduino with ev3?
@skrima5376
4 жыл бұрын
Just an NXT with multiplexer
@aarravoltics4592
4 жыл бұрын
@@skrima5376 ok How many sensors and motors?
@feib4012
7 жыл бұрын
Hi very good job, your robot is fantastic, only one answer... there is a light or color sensor in the front of the robot for see the ball or an other sensor? thanks very much
@adren0053
7 жыл бұрын
Feib Since the walls in the room are white and the corner for the balls is black we can differentiate between them by using a light sensor at the front.
@feib4012
7 жыл бұрын
ADREN00 good idea, we use two touch sensor in the forward-right and in the forward-left (sorry for my english but im italian) but for the ball what do you use? thanks for the question
@adren0053
7 жыл бұрын
We realized the balls tend to roll to the outside of the room so we decided to drive at the outside of the room without knowing if there are some balls or not. For the balls in the middle of the room we use two Sharp infrared sensors which we can connect to the NXT by using a transistor circuit. So basically the robot doesn´t detect most of the balls and the path for the robot is always the same.
@viniciusduque8823
5 жыл бұрын
Do you have the building instructions of the robot?
@user-co8ql1dq9k
6 жыл бұрын
wow
@mitjanovak6082
6 жыл бұрын
Another amazing RCJ project. Check it out: kzitem.info/news/bejne/lWp_wImQbp9_q20
Пікірлер: 20