www.teccotoys.com music: no agenda by foxxy mulderr www.foxxymulde... Music promoted by www.free-stock... Attribution 4.0 International (CC BY 4.0) creativecommon...4.0
what brand printer/wash are you using UV station. P.S. what song is that in the back ground I love it!
@teccotoys
9 ай бұрын
In this Vieo, a Elegoo Mars 3 printer is used. Wash and Cure stations are by Formlabs. Music is: no agenda by foxxy mulderr www.foxxymulderr.com
@jareddarby3481
9 ай бұрын
@@teccotoys thanks really appreciate your quick response! Big fan of your videos/toys!
@milleniumeagle7897
7 ай бұрын
Would you be able to print these with elegoos water washable resin? or would it be too brittle?
@teccotoys
7 ай бұрын
I haven't tried that resin yet, but I expect it could bee too brittle. Generally you will need a tough resin that has some felxibility for the best experience. Since the parts are all snap fit, a good flex is required so they will not break during assembly. If in doubt, I can always recommend Resione TH72. At only 35$ US per Liter it is quite affordable and has unmatched quality for that price range.
@milleniumeagle7897
7 ай бұрын
@@teccotoys I’m unfortunately in an area where I cannot use alchohol to clean off prints so I’m stuck using water washable, I’ll just have to be careful about snap fitting and just glue them in a pose
@davidmarroquin4797
4 ай бұрын
What resin do you recommend for action figures?
@teccotoys
4 ай бұрын
I recommend Resione M58 or TH72 or Anti-Impact. You can also mix them to get different properties. TH72 and Anti-Impact have more flexibility and are tougher, M58 is less flexible but has the best surface/detail properties.
@srdjandimic5035
Жыл бұрын
🥰🙌⚡️
@81lego81
10 ай бұрын
I tried printing this with PLA+ with an Ender 3 v2 and no matter what scale I print it at, the joints near the forearm always end up cracking on me. Do you have any tips on what settings I can change to avoid this?
@teccotoys
10 ай бұрын
Unfortunately, I'm not familiar with FDM printing, but I know that other customers have successfully printed with FDM printers. Check out our discord server. There are people around using FDM printers, maybe they can help you achieve better results: discord.gg/8akaSS8g
@whozyourdaddy
Жыл бұрын
Could you just print, paint and send it to me?
@teccotoys
Жыл бұрын
sorry, unfortunately I currently don't have the capacity to produce on demand printed and painted models.
@pvsfilms7173
Жыл бұрын
@@teccotoys same i don't have 3d printer that is why i am waiting till it hits in online with painted
@kailiciousthumbsup
Жыл бұрын
Can you tell me want resin you used and the exposure
@teccotoys
Жыл бұрын
for the action figures, I currently use a mix of Resione Anti-Impact and TH72 resin (Anti-Impact 70 parts, TH72 30 parts). I print with a layer exposure of 4.0 seconds. Post Uv curing time is 60 minutes.
Пікірлер: 18