Those jacks stands are the real winner here. Just so I know. How many wooden pallets do I need to achieve that perfect height? I’m heading to the alley of my local supermarket right now to get my jack stands sorted.
@elariomontoya8683
8 ай бұрын
What size of spacers do you use in the front under the coilovers?
@andygsgarage
8 ай бұрын
Mine are 2 one inch spacer from stance
@tareqmohammed5109
3 жыл бұрын
Thanks for the review, man. Just got mine on too. I agree the washer stacking is kinda janky, I know it'll work I just hate how it looks lol. I didn't have the problem you did with knuckle fitment. Tell me something, how are you getting the arms on and off with the rack in place? I always hafta pull mine to get sockets on both sides of the control arm.
@andygsgarage
3 жыл бұрын
I've always had luck using a wrench on the rack side . It's tight but can be done
@tareqmohammed5109
3 жыл бұрын
Followup - looked at them again and tbh it needed a washer under the ball joint cap nut just like yours did. T3 includes 2 more washers than I think anybody would need for fitment in the xmember, so maybe that's what they are for lol
@Retroyoda
Жыл бұрын
How’s the ride? Lots of noise?
@Dookieandsons
3 жыл бұрын
Where did you get this entire kit from that is just a bolt on kit no customizing It Bolts right on how much is it and where can I get it
@bigdfitness5020
Жыл бұрын
Technotoytuning
@CowboySkeetbop
3 жыл бұрын
Ayyye good job my man, was hoping someone did a video on this and I appreciate you leaving in all the minor details.
@andygsgarage
3 жыл бұрын
Thank you. I'll be doing a driving video soon. Waiting for the salt to clear of the roads
@Dookieandsons
3 жыл бұрын
Yeah where can I get those and how much are they my car is lowered really low with some maxspeedingrods coilovers and I was looking at some extended run in but I think I'm just going to put some bump steer spacers basically I want to go with the whole kit you got but I sure like how those extended outer tie rod ends look they just have a mean look to him with the long stud LOL but let me know I have an 86 that I'm currently in the middle of a turbo swap I followed the little white Z from the Z garage I followed his write-ups and I've got a lot of parts
@noobphice8303
3 жыл бұрын
Hey, I’m having quite a bit of difficulty doing the knuckle fitment
@andygsgarage
3 жыл бұрын
What are you having issues with ?
@JiroProject
2 жыл бұрын
Did you ever hit t3 up about the sway bar links and that lower ball joint? I think with those you can eliminate the rcas
@turdrocket
2 жыл бұрын
what tension rods did you originally have on it?? It looks like the tension rod off of an 88. but its adjustable. that is what I need. please help
@andygsgarage
2 жыл бұрын
They were aftermarket tension rods for an 88 z31. I don't believe they are available anymore
@turdrocket
2 жыл бұрын
@@andygsgarage crap....
@andygsgarage
2 жыл бұрын
Stance still makes adjustable tension rods for the z31
Пікірлер: 28