Looks like I still have problems with the Minor loop signal.
Using RTL-SDR as a service monitor receiver with cubicsdr software for control and reception.
Upon turning on the transceiver again to check the minor loop signal - the minor loop signal
was not present. After abotu 5 minutes the minor loop signal appeared again as two competing
signals each moving in opposite directions near 44.75 Mhz.
Not sure if pulling the minor loop board AGAIN and RESOLDING it again would help.
OR if this is a component issue.
Or simply the core / slug in the minor loop VCO needs adjusted differently.
This activity is chewing up hours of time which equates to days of time.
Негізгі бет Тәжірибелік нұсқаулар және стиль Ten Tec paragon how to adjust Minor Loop, VCO and debug major loop unlock issues with a scope
Пікірлер: 1