Just bought a 2016 and fixin to do front and rear bearings. Nice job.
@halo-vision6623
2 жыл бұрын
It's not a hard job, especially if have a little press. If have any questions just holler. Thanks for watching...
@larryfield5380
2 жыл бұрын
Thanks. I have a 6 ton press being delivered tomorrow. Just figured out I have to change all the front bushings as well. Figured I my as well put a2" lift and heavy duty tie rods on while I'm at it.
@halo-vision6623
2 жыл бұрын
Bushings aren't to bad, just little slow if haven't done them before. 2" lift be simple since you'll have everything off anyhow. Lol I've not done tie rod change yet, I've aligned them twice though.
@billboyd870
2 жыл бұрын
Good job all the way!
@frankellet951
2 жыл бұрын
Where can I buy the bearings?
@Crawl_az_rc
2 жыл бұрын
Do you not need to grease the bearings?
@halo-vision6623
2 жыл бұрын
It would be good to while have everything apart.
@juanpontif7577
10 ай бұрын
I wouldn't. The bearing is machine pressed and grease in such a tight fit can have a hydraulic effect. You can grease the inside going inot the axle once it's pressed.
Пікірлер: 10