@@tntrace3765 I have to be careful with mine. I have the old design I think.
@tntrace3765
3 жыл бұрын
@@ItsBinhRepaired im using my own protection.just chekout my other videos.Without protection you will lost your bearings after 50-150km
@Born2Ride108
3 жыл бұрын
So many holes for water to to get in the EXN. I would open the wheel and inspect it. Take the cover off the heat sink. You will not like what you see!!
@tntrace3765
3 жыл бұрын
I've protected not only the bearings. My ExN hermetised totally
@Born2Ride108
3 жыл бұрын
@@tntrace3765 did you seal the intake hole under the mother board? there are 2 big openings in the EXN. One for fan/heatsink cooling the other for MB. I guess you've seen all the videos of GW wheels blowing up? This is due to water getting on the batteries.
Пікірлер: 8