Thank you for these clear diagnostics. Got 4x4 on my kodiak again! 👍
@mikeg.5854
Жыл бұрын
Thank you very much! Your videos are very helpful!
@dlobaugh
11 жыл бұрын
Ryan - it is hanging off the display screen. White/cream color, looks just like the 3rd one in the video.
@adamschafer994
3 жыл бұрын
Do you have a video on how to disassemble and repair the plugs/wires that go to actuator on the harness side?
@501PartsTech
3 жыл бұрын
Adam, not at the moment but we will put that in box to make one. Stay tuned.
@matthewdiduck
2 жыл бұрын
I too have the Same question.! I have a 2013 yamaha grizzly 700. Only thing I haven't changed now is the 4wd switch. But I did clean it just like your other videos. I also ordered a servo motor from you and changed it too. Than I set it back into 2WD. (It's stuck in 4x4 right now) But I didn't manually turn it inside the diff itself to 2wd. Could that be the problem? I also put 2 new relays. And the 3rd one is fine. I also tested the old ones and new ones the same way you have in previous videos. Should I have set my diff inside to 2wd also or changed my switch? It doesn't seem to get power, just has ground when I used a light tester. I also can't hear it engage. It's still stuck in 4wd
@perrytaylor7660
Жыл бұрын
😊j look😊😂uui 🎉u🎉
@matthewdiduck
6 ай бұрын
I'm back again. I changed my switch with a brand new one, and changed my whole actuator with a new one and it's still stuck in 4wd. I even reset and timed everything back to 4wd, and it's still stuck in 4wd. There is another reason when I plug it back in it always turns on and switches automatically to 4wd like it's getting constant power somehow. I also recently changed the wiring harnest 3 years ago, so I can't see it being a wiring problem, but idk? Any suggestions?
@meliusshooting8344
10 ай бұрын
I have a 2004 Kodiak 400 that’s stuck in 4wd. I can’t find the relay to test it. Mine is definitely not under the seat.
@501PartsTech
10 ай бұрын
Look under the front plastics up by the handlebar stem.
@ryan74382
11 жыл бұрын
I have a 2003 Kodiak 450 4x4. I only have 2 relays under seat, the manual says I have a 3rd relay on front right side under fender. I cannot find the third relay do you know where I can find it at?
@EricRush
5 жыл бұрын
Same machine, same question. Thank you, Daniel Lobaugh.
@EricRush
5 жыл бұрын
Spoke too soon. Still can't find the damn thing.
@meliusshooting8344
10 ай бұрын
I have a 2004 Kodiak 400 that’s stuck in 4wd. I can’t find the relay either. Mine is definitely not under the seat.
@greatwhitenorthlife2327
3 жыл бұрын
My kodiak has 2 four post solenoids, only thing wrong is with power to it I get no continuity... suppose that's an issue.
@jeffthiessen5187
8 жыл бұрын
Thanks for posting this series of videos they are very helpful. I have gone through all tests except the third relay I haven't found yet but so far have confirmed my switch works. actuator runs both directions fine on the bench. I have power at the harness in various locations depending on the switch position. two black relays test ok. however with the actuator plugged into machine it will not engage 4wd. however when I tried to manually set the actuator and differential into 4wd as soon as I flip the switch to 2wd it disengaged fine and won't re-engage. does this point to a bad relay or is there a separate safety switch other than the locating switches in the actuator itself?
@mathewpoettker8474
4 жыл бұрын
Hey man I've got an 02 grizzly. The diff lock would stay on but would flicker on and off until it's finally only staying on. I've replaced the switch and servo motor. I pulled the cdi and one of the connection was all corroded. Is there a way to test the cdi?
@501PartsTech
4 жыл бұрын
No way to test the CDI. Had to be replaced or swapped with a known good one.
@trailerparkplug1758
4 жыл бұрын
Hey man wondering if you can give me some help here. 2004 Kodiak 450 4x4 with diff lock. 2w and 4W both fine on hi and lo. When I press difflock it flashes but won’t engage. I don’t hear the servo clicking like it does when switched into 4wd. You think my servo motor is bad?
@501PartsTech
4 жыл бұрын
I would pull the servo and check it. If it's sounding the same as when it goes into 2wd and 4wd but not engaging into diff lock, you need to open it up and see why. Remove it from the front diff, keep it plugged in and try to go into diff lock. See what happens and if the gear on the servo is actually turning. Also push the slide gear inside the diff, over into diff lock with your finger and make sure it goes with ease.
@TOMMYCC73
6 жыл бұрын
Big Thank you!!👌👍
@perrytaylor7660
Жыл бұрын
B b😮 c. 😊😊 😅 ib😊ķn 😊nì b😊I
@reymondrodriguez342
5 жыл бұрын
My kodiak keeps blowing my 4x4 fuse any ideas what it could be
@501PartsTech
5 жыл бұрын
Reymond, here is our troubleshooting page. You'll be able to trace down the issue there. Check the servo on the front diff first, that's the most common issue. We have videos and how to write ups on the troubleshooting page. www.501parts.com/downloads/
Пікірлер: 28