Good video but man a written set of instructions would be nice for use in a garage.
@projectLSaudiA4
16 күн бұрын
Great job! There's a table in the ECU for gearbox type (3D126A Codiermatrix für Codierzelle Getriebeart), which might help with rev hang? I'm sure you'll figure it out!
@brianwhiteash7884
Жыл бұрын
Good stuff! Just replaced the fitting coming out of the sensor that leads into the drivers side hpfp.
@SheldonWyngard
Жыл бұрын
Thanks for all the steps! Great video. Just to confirm, will the stock high pressure fuel pump work?
@tannerc.1454
Жыл бұрын
If still stock turbos yes
@cg-ji8ul
11 ай бұрын
Great video, could I also connect signal cable directly to one of the ecu cables in engine bay
@ΑΝΔΡΕΑΣΣΤΑΘΑΣ-γ2κ
Жыл бұрын
Very nice car s8 plus....
@ericlinn8647
Жыл бұрын
Can the flex fuel sensor be installed without the upgraded fuel lines?
@MrTykirst
Жыл бұрын
No sir, the oem line are all hardlined on the motor and no place to tap into the hardlines. The hardlines are also smaller, and feed into one HPFP first then from that pump to the other, so the drivers pump basically gets the first pumps leftovers and with the need for more fuel for E you’ll start getting lower pressures on the drivers fuel pump unless you split the lines to go to them equally
@ericlinn8647
Жыл бұрын
@MrTykirst yep! I've since installed all new lines that split the fuel pumps evenly. Running about e75
@braxtonhamby9658
Жыл бұрын
Just got mine with the IE hpfp upgrade installed picking the vehicle up tomorrow morning now just need to find some high quality corn gas around me 😅
Пікірлер: 16