The fix doesn’t have to be so expensive. If you get an F430 without cracked headers, IMMEDIATELY REMOVE THE EXHAUST BRACKETS. The center mount is all you need, the additional brackets are actually too tight and what cause stress on the headers, leading them to fail. Should you NEED new headers, get the “top speed” headers. They’re about $1000-$2000 USD. Not bad at all. And it’s a DIY job if you’re handy.
@christschool
2 ай бұрын
The brackets are half the problem, the other problem is the welds on the headers were not done correctly for the amount of stress. The brackets really become a problem when the motor mounts start to deteriorate and the engine begins to move around more during shifting, causing further stress from the rigid mounts. The only fix is to replace the headers and get the sport exhaust from Ferrari.
@prcc
10 күн бұрын
The opening music is nothing short of an auditory assault. Brutal.
@Macedonia270
7 күн бұрын
Where is this?
@jayi836
4 ай бұрын
Thanks for posting great content!
@lawrence.centinales
Жыл бұрын
great to know i really have my eyes on this car in the future one of my dream childhood cars
@jaswingrove
5 ай бұрын
i can’t recommend the scud relay. had one in my similarly gearboxed R-tronic audi R8 and all it gave me was errors and issues. removed it more than a year ago and have had trouble free gearbox since
@johnforeman634
11 ай бұрын
I’ve had an 08 F430 Spider for three years now. It has run flawlessly. I did need engine mounts though. They make a huge difference. Anyone looking at one of these should check them. Not expensive if you do it yourself.
@iFumoffu
4 ай бұрын
great video, very knowledgeable and well presented.
@kalibao.official
Жыл бұрын
Thanks for sharing Carl!
@Gotadime92
Жыл бұрын
Holy shit the intro music 😂
@MUSHROOMSOUPBAND
7 ай бұрын
120 to 160 in the States now depending on Miles and equipment USD 2.24
@KandiMan
5 ай бұрын
Why is there so much rust?
@terrychan8958
2 ай бұрын
Great sharing
@bobjones7776
11 ай бұрын
I thought saggy exhaust means engine mounts need to be redone?
@CarlsGarage1
11 ай бұрын
well, the bracket on each side of the muffler section are known to fail on 430, also inspect the headers too. I had to replace the headers because the factory one was leaking slowly, and the heat it produced can damage the wires and pumps over times. Also, when the bracket fails, the vibration can also break the tail light clips.
Пікірлер: 16