I made the Kids Chair from steel pipes with homemade rooller bender.
I wanted to bend steel pipes for this project.
First, I built the bending machine you see in the beginning.
It took me a lot of testing and a lot of time until I could bend it nicely.
Then the seat part was ...
Pre gluing→ finishing the edges→ disassembly→ gluing.
Because if the arm is an integral seating surface, it can't be installed on the frame.
The backrest and steps were made off-camera.
The screw hole hardware was made out of brass.
The song was created using the garageband app to create a song that I remember with a friend's client.
My computer is about to explode with the song writing and animation production.
Hope you enjoyed the video!
Thank you!!
///////////
chapter
00:00 intro
00:44 cut&bending
03:12 welding
05:45 flamingo!
06:17 seat
08:30 assembling
12:07 ending
12:40 Princess YACHICA
///////////
Please support me on patreon!
↓
www.patreon.com/user?ru=%2Fed...
///////////
I'll send you a sticker (along with an international return postage stamp) if you'd like, on sns Send me a message!
more:
/ jp.struttin
jp-struttin.com/
#homemadebender #furniture #weldingprojects
Негізгі бет Тәжірибелік нұсқаулар және стиль The process of bending tube to make an amazing kid's chair | Small workshop with limited equipment
Пікірлер: 15