I finally decided it was time to build an proper anvil stand. Unfortunately i've come to find out that most floors/surfaces are not truly level. By going with 3 legs you can eliminate wobbling. I splayed the legs at 10 degree angles. This was a very fun build, that only took about a day and a half.
Tools & products used:
General tools digital bevel guage amzn.to/2nNHpMr
Dewalt DW862 Cold Saw - amzn.to/2etobWb
Dewalt 20V XR Brushless Drill amzn.to/2ncJIZe
Porter Cable drill press
Dewalt Flexvolt Angle Grinder - amzn.to/2lquDSZ
Lincoln Electric 140C Mig welder - amzn.to/2fhWbGd
Dewalt 4 1/2 Angle Grinder - amzn.to/2ejTkbd
Bessey Auto adjust toggle clamp amzn.to/2od28VW
Sculpt Nouveau Cleaner & Degreaser - bit.ly/2lIJQd6
Sculpt Nouveau Copper Plate Patina - bit.ly/2mDTdjj
Lacuqer clear coat - amzn.to/2mDXF1G
Generic propane torch/weed burner amzn.to/2paQf7n
Boiled Linseed Oil amzn.to/2oHGZa6
Tracklist:
1. Jahzzar Jardins du Luxembourg
2. Cullah Comfort To You
Негізгі бет The Ultimate Anvil Stand | DIY
Пікірлер: 316