I use that on my masters too! Ill also put a comp with a high atk before it to make the track dance! (Dance with the drums!!,)
@We_Run_Up_Hills
3 ай бұрын
And pro mb before all that for compressed lows
@valley-artifact
8 ай бұрын
this video would've been better if there was a comparison test between the method shown, and just adding the same amount of gain normally, you could've also used phase cancellation between the 2 versions to isolate the differences, i'm really skeptical about the Pro Q3 gain boost being any "clearer" than normal. on a different note, camel crusher isn't limiting the audio it's just hardclipping the peaks of before it gets to the master, you can just use a hardclipper for that, the reason it sounds the same is because Ableton sensibly hard clips the matter anyway when you go over 0 db. but is a good idea to handle peaks earlier in the chain since it gives you more control over how they're handled.
@duecednb
8 ай бұрын
The ProQ gain tip I got off another producer (I have a feeling TC mentioned it at some point but can’t be 100% sure it was) but when I’ve compared against the stock Ableton gain it’s sounded clearer to me - a comparison in this video definitely would’ve been a good addition, same with comparing just gain vs this method. However the camelcrusher prevents clipping, maybe saying it acts as a limiter isn’t exactly true in the conventional sense, but you can see this at 4:54 that even when it’s on 0% mix that it prevents the audio from redlining/going above 0db - which is what a limiter does. I’ve titled this is an unorthodox method for a reason - it does the job but I know not everyone will like it or agree with it
@jacklyons6063
7 ай бұрын
If you logic multi effects phat fx does the same clipping. Trick when set to init patch
@duecednb
7 ай бұрын
Makes sense, Phat FX is what CamelCrusher/CamelPhat became since Apple bought Camel Audio
Пікірлер: 8