I know this video is long but if you want to know if the V1Kit from Rigid works on the Vevor pro press then check this out. #Vevor #ProPress #Rigid #V1Kit #Plumbing
I just purchased this used it for 6 presses of 3\4 copper fittings for water no leaks so far. Very happy with it, just a little heavy. Came a with 1/2to 2 inch copper press dies 2 batteries they do look like Makita style batteries. But I cannot verify. The manufacturer says it presses at 37n. Which is over 8000psi.
@levi5016
4 күн бұрын
@@RockoRocko-rz7kx I agree with everything you are saying and yes you can use Makita batteries with the Vevor propress. Glad you got it it’s a really nice deal.
@javierbramasco4020
Ай бұрын
Let the work begin!
@levi5016
28 күн бұрын
@@javierbramasco4020 let’s get it!
@christopherbeaulieu4942
27 күн бұрын
I read it will also take makita batteries. Don't know if it's true bit would be nice to know
@levi5016
27 күн бұрын
@@christopherbeaulieu4942 yes that is correct!
@Antiquefirearms724
4 күн бұрын
How's the tool holding up? im really curious cause im dying to get the pro press tool, so i might have to go with the vevor!
@levi5016
4 күн бұрын
@@Antiquefirearms724 it’s still holding up really good. I used it yesterday with the rigid C1/V1 jaws for a tankless water heater install. I’ll be posting that video today.
@TOOL_TECHNICAL
15 күн бұрын
How long until vevor wants you to send it in for calibration? I assume there's certain amount of times it will actuate before needing to be checked the right KNs of force range
@levi5016
15 күн бұрын
@@TOOL_TECHNICAL after 30,000 crimps. It shows on the Vevor pro press how many times it’s been used. I don’t know if Vevor provides that service though.
@donfrussell
11 күн бұрын
RLS jaws? which are compatible? Rigid?
@levi5016
11 күн бұрын
@@donfrussell If the rls jaws from Milwaukee or Rigid fit on the Milwaukee m18 pro press, then yes they will fit on the Vevor pro press as well.
Пікірлер: 12