I tried this mod, and I can say that I can enjoy low frequencies at lower volumes and don't have to open the volume too much. 40hz tried and tested. Thanks a lot!
@matus3303
9 күн бұрын
No problem, glad I helped
@jhonnh.7012
Ай бұрын
I came to thank you, I bought the piece and it removed the distortions in songs with very low sub-bass, in addition to adding harmony to the sound. I bought 4 pieces, but I'm only using 2 and that's enough.
Great, but there could be a before and after comparison of the upgrade. And when capturing, you don't notice any distortions in this box. Do you have a link to the magnetic supports used?
@matus3303
Ай бұрын
Hi, sorry for no comparison but the glue is strong so it is hard to take off-a good thing so it does not fly off. It improves the distortion in some songs. Some songs do not distort. Anyway it makes it sound better with deeper bass. There is still some distortion but the improvement is huge when playing bassy music. vi.aliexpress.com/item/1005003176227244.html?spm=a2g0o.order_list.order_list_main.40.20d41802w2HtgN&gatewayAdapt=glo2vnm
@asunavk69
21 күн бұрын
i have a mifa wildbox, speakers does sound overdriving at higher volumes with basskick, i notice a soft suspension from the passive radiators perhaps similar to the og motion boom which seems quite good, but with all the distortion would adding weight to it help solve the issue?
Thanks for the video, I'll buy it and test it. On my Tribit I normally use an external EQ and increase the Subbass. But I also notice distortions when the music oscillates between Sub-bass of -40hz to upper bass. Tends to make an annoying noise. Have you ever thought about using 3 of these supports instead of 2? How many grams will be in these supports?
@matus3303
Ай бұрын
I think that one on each side is enough. It improves a lot but two gets you tuning of around 38Hz. There is a Low-Cut under 30. The amplifier does not give signal to the speakers so This may be the sweet spot. Most music is not mixed down under 30Hz
@se_arz4284
Ай бұрын
What is the firmware version of the speaker?
@matus3303
Ай бұрын
Hi, it is firmware 3.5
@dex12223
21 күн бұрын
@@matus33033.5 how about battery life ?
@vuilledeeresh4116
12 күн бұрын
Lowering the tuning point of the passive radiators can cause damage to the drivers if not done correctly
@matus3303
12 күн бұрын
Not sure. Over-excursion happened with the stock tuning. I have tried it with freqency generator and it does not reach the xmax of the drivers so it is even less harmful then it was.
@nikolaygruncharov7283
5 күн бұрын
I heard that actually it is better the weight to be on the speaker cone itself, but your idea is nice too. What about the midbass? Does it sound thinner and less punchy? Any differences in sound, except the lower freq response?
@matus3303
3 күн бұрын
I doubt it would be fine for the speaker. sticking the weight may damage the speaker and it would sound very different all the parameters would change. Sounds same just deeper bass. Tuning the bass radiators does not change the woofer parameters
@TheyTyroneShoelaces
4 күн бұрын
do you think this hack would work on the W-KING?
@matus3303
3 күн бұрын
Yes
@Deeesquare
Ай бұрын
what is the app you using for the frequency checking & are you using the Eq settings from the Tribit app?
@matus3303
Ай бұрын
Hi, it is called "Signal Gen"
@Deeesquare
Ай бұрын
@@matus3303 thank you Matus
@Deeesquare
Ай бұрын
Also with this can you help us with a an image with the best Eq settings for the speaker via the Tribit app
@sf49erswarriorsgiantsgumba99
3 күн бұрын
So when you put the magnets on there, tou get more bass?
@matus3303
3 күн бұрын
You get more deep bass. And reduced bass at the peak of the bass radiator. So the speaker sounds cleaner with less distortion.
@sf49erswarriorsgiantsgumba99
3 күн бұрын
@@matus3303thank you sir! I was also wondering if I can use a diffferent type of material to stick on it, instead of the magnetic phone holder. I was thinking like a different kind of metal decal logo of some sort. Or does it have to be magnetic? And will there be a difference of the bass, if I go a little heavier on the decal? I know it’s a lot of questions. Lol
@matus3303
3 күн бұрын
@@sf49erswarriorsgiantsgumba99 The magnetic phone holders weigh 18grams each so 36grams at each side. it does not matter what material you use but use something at least 15 grams to 40 grams and you should be good
@sf49erswarriorsgiantsgumba99
3 күн бұрын
@@matus3303 ok thanks again! 🤙🏼
@Indian_Speaker_Guy
Ай бұрын
What's the weight of those mag??
@matus3303
Ай бұрын
Hi, 18grams each
@jovanybadua5212
Ай бұрын
nah the boombox 3 is crap
@JBLBASSENJOYER
17 күн бұрын
How? its arguably one of the best portable bluetooth speakers.
@jhonnh.7012
Ай бұрын
One more question my friend, when adding these extra weights, you gain a response at low frequencies, right?But at higher frequencies does your box lose SPL as happens in boxes with a lot of weight on passive radiators?
@matus3303
Ай бұрын
Yes, it decreases spl at higher frequencies but it sounds more balanced
@albertalbertov6406
Ай бұрын
Спасибо вам за идею! Скажите пожалуйста, лучше по две штуки поставить, или по одной? Просто по две, выглядит более красиво и симметрично
@matus3303
Ай бұрын
Hi, even one on each side is enough. I bought these for an ipad for my car so I had 4. Ipad did not hold so I used them on this. You can cover the tribit logo almost perfectly with one if that helps
@albertalbertov6406
Ай бұрын
@@matus3303 спасибо за ответ! У меня есть четыре штуки, вот и думаю по 2 с каждой стороны поставить, или по одной. В каком варианте будет лучше звук?
@matus3303
Ай бұрын
@@albertalbertov6406 I prefer both but even one is a improvement. You can try just one and then test with two it can be taken off. Maybe not press it hard so you can take it off more easily
@albertalbertov6406
Ай бұрын
@@matus3303 спасибо! А вам с двумя с каждой стороны нравится? Вы в каком варианте предпочитаете?
@jhonnh.7012
22 күн бұрын
I bought 4 pieces, each one weighs 25 grams, I only use 1 on each side because the sound is much better and with more definition and volume.
@luca-dv4hb
13 күн бұрын
Wenn man Ahnung von Equalizern hätte dann wäre einem auch klar das der Lautsprecher bei dem EQ übersteuert😂
@matus3303
13 күн бұрын
I know. The speaker is overloading even with -6db in some songs so the EQ is not the problem. After this mod it does not distort as much even with +6db. I doubt anyone uses this speaker for serious listening anyway. If you have any idea how EQ works if you lower the gain by 6db and add 6db at 50hz it is not going to overload. I have been doing EQs with REW + EqualizierAPO, Genelec GLM, DBX sound processor This speaker is DSP corrected but we have no idea which filters are there and how they were set. You will not get a pure sound from this because of that.
@edwinquispe2335
Ай бұрын
Hola amigo saludos desde latinoamerica Perú. Una pregunta es la nueva presentación la nueva versión de tribit stormbos blas ???🤔🤔
@matus3303
Ай бұрын
Hi, it is not a new version. Just a modification I did
Пікірлер: 53