Haha sure looks like it but it carries my B tank and it’s made by TurboTorch
@syreplays5079
2 күн бұрын
I applaud you for using acetylene for everything. I’m way too lazy to lug my b tank around like that, and I have the same bag. #letmebefatandlazy
@Monkeywrench864
19 күн бұрын
Hey nice video. BTW, switch to Johnsons paste flux. I switched recently over from the Everflux. Way, better. Not dealing with the green slime. Your work well look great
@PlumbingExplained
19 күн бұрын
I’ll check it out, thanks for the recommendation
@Trenchwarfare76
3 күн бұрын
I have 28 gallon lowboys in a small cubby underneath the kitchen coutertop. Such a pain in the ass, can't get anything bigger inthe space so my resident complain that not enough hot water to take a bath.
@FranciscoMartinez-uc3hx
3 күн бұрын
Why didn't you replace 3/4" copper mip?
@PlumbingExplained
3 күн бұрын
Because he’s moving and elected not to spend the extra money to have it done
@plumber1874
19 күн бұрын
You should know why the water heater is on a stand and why it's. Now redundant
@PlumbingExplained
19 күн бұрын
I do know, ever since they went to FVIR it is redundant but they still make us do it lol
@drduandada4218
18 күн бұрын
It’s a gas heater and it’s code to be on a stand and you should know this already.
@jl591
18 күн бұрын
Maybe its code where you live to put it on a stand
@drduandada4218
18 күн бұрын
@@jl591 you better watch the bass in your voice when you comment on a comment that I’ve commented on next time boy. 😆😆😆😆😆
@PlumbingExplained
18 күн бұрын
@@drduandada4218 Since gas heaters now have an enclosed burn chamber they became flammable vapor ignition resistant, they no longer need to be on a stand based off the reasoning for the local code. Didn’t say I didn’t know why they’re on a stand just said I think it’s funny
@syreplays5079
2 күн бұрын
@@jl591it’s UPC. Gas heaters need to be a minimum of 18” from the floor.
@donaldblank8873
19 күн бұрын
Never put heat to a ball valve.
@PlumbingExplained
19 күн бұрын
I never had any issues with my ball valves I typically exclusively use swet ball valves very rarely do I use a threaded one.
Пікірлер: 19